Cont.

From

Previous

Page

➔

➔

➔

➔

STEP 23: Use a OEM bolt that was just removed to plug the driver’s side bolt hole.

At this time double check the woofer for proper operation. Also run speaker wire to the enclosures mounting location and connect to the terminal.

STEP 24: Place the enclosure in the mounting location. With L-bracket facing to the front of the Expedition. Use the other OEM bolt that was removed in STEP 22. Secure the L-bracket to the floor.

STEP 25: Using a 7mm socket, secure the wire harness that was removed in STEP14.

STEP 26: Place the front portion of the modified black inner console, in front of the enclosure.

Route the wire harness under the driver’s side of the enclosure and to the inside of the rear mounting bracket.

➔ ➔ ➔

STEP 27: Secure the front portion of the modified black inner console to the dash, using the pair of bolts from STEP 7.

STEP 28: Attach the suppled backing loop tape to both bottom edges of the modified back inner con- sole.

This will help to reduce the vibration rattle between the inner console and the outer walls.

STEP 29: Secure the outer walls to the enclosure

STEP 30: Secure the rear outer console, from

and the modified black inner console.

STEP 12.

Use the supplied (2)#6-32x1/2” pan head screws

 

and (2)#6x3/8” flat washers to secure the outer

 

walls’ top mounting tabs to the enclosure.

 

Continued on Next Page ➔

w w w . j l a u d i o . c o m

SB - F - EXPDCNSL/10W3v2, JL AUDIO, Inc 2004

Pag e 4

Sheet SKU#011106 Revision6/30/2004