S T E P 4
Set the enclosure into the trunk on the passenger side of the car, familiarize yourself with the location of the threaded insert at the front top of the enclosure. Rotate the enclosure into place.
S T E P 5
Once the enclosure has been rotated into place, fasten the included Custom Bracket using the Hex Head Bolt, Split Lock Washer and Fender Washer as shown on enclosure.
S T E P 6
From under the vehicle, start the Hex Head Bolt, Split Lock Washer and Fender Washer (see DETAIL Below) into the threaded insert in the bottom of the Stealthbox®. DO NOT
TIGHTEN AT THIS TIME!
THREADED INSERT | D E T A I L |
STEALTHBOX WALL |
|
VEHICLE SHEET METAL |
|
FENDER WASHER |
|
LOCK WASHER |
|
HEX BOLT |
|
S T E P 7
Push the enclosure back into the side until it is snug in place, Mark the spot where the bracket lines up with seat brace structure, drill a 1/2” hole.
Before drilling, always make sure that you are not going to be drilling into any gas lines, brake lines, tires, transmission lines, electrical wiring, exhaust systems or anything else that might cause a reduction in your weekly pay.
Always wear eye protection when drilling!
S T E P 8
Install hardware as shown through the Bracket and the hole drilled in Step 7.
S T E P 9
Tighten the hardware installed in Step 8 and the hardware from below the car installed in Step 6.
S T E P 1 0
C O N G R A T U L A T I O N S !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an amplifier recommendation and basic
Page 2 • JL Audio, Inc 2009 | Continued on Next Page |
