S T E P 1 2

Place a supplied 5/16-inch lock washer and then a supplied 5/16-inch flat washer onto each 5/16-inch hex head bolt.

From inside the trim piece, place two of these bolt assemblies through the holes that are on the back side of the trim piece.

Place a supplied 5/16-inch flat washer onto each exposed 5/16-inch hex head bolt. Hand tighten each supplied coupling nut onto each 5/16-inch hex head bolt. Look to STEP 14 for a cross section illustration.

S T E P 1 3

Place the painted interior trim piece back into the vehicle.

Mount the painted interior trim piece with the allen screws that were removed in STEP 3.

 

 

 

SB-GM-C6CONV/8W3v3_INSTR_SKU#011225

I N C L U D E D H A R D W A R E

 

 

 

(2)

3/8-inches -16 x 1-inch Hex Head Bolts

(2) 3/8-inch x 1-1/4-inches Fender Washers

(4)

5/16-inch Split Lock Washers

(2)

3-inches x 3-inches Wax Squares

(2)

3/8-inch Split Lock Washers

(2)

5/16-inch -18 x 7/8-inch x 9/16-inch Coupling Nuts

(4) 3/8-inch x 2-inch Fender Washers

(4) 5/16-inch -18 x 1/2-inch Hex Head Bolts

(8)5/16-inch Flat Washers

S P E C I F I C A T I O N S

Enclosure Type: Acoustic Suspension (sealed)

Driver Type: 8W3v3-8

Nominal Impedance: 4 ohm mono or 8 ohm stereo

Continuous Power Handling: 300 Watts

P O W E R R E C O M M E N D A T I O N

JL Audio recommends using a high quality amplifier such as the JL Audio 250/1.

The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.

PAINTED INTERIOR TRIM PIECE

 

5/16-inch FLAT WASHER

5/16-inch FLAT WASHER

5/16-inch FLAT WASHER

5/16-inch FLAT WASHER

5/16-inch HEX BOLT

5/16-inch HEX BOLT

5/16-inch SPLIT LOCK WASHER

5/16-inch SPLIT LOCK WASHER

5/16-inch COUPLING NUT

 

 

BULKHEAD

S T E P 1 4

From the back side of the rear bulkhead, place the last pair of bolt assemblies through the factory holes.

Place a supplied 5/16-inch flat washer onto each hex head bolt, between the painted interior trim piece and in front of the rear bulk head.

Hand tighten these bolt assemblies to the coupling nut that is attached to the painted interior trim piece.

+12VDC Ground Remote

Preamp Output Section

Bass Control

Amp LP Filter

Amplifier Input Section

 

Output Mode

Infrasonic Filter

Mode/Slope

Input Voltage

Input Sens. Signal Sensing

 

Full-Range/Low-Pass/High-Pass

 

Off/30Hz

Off/12dB/24dB

Low/High

Off/On

 

 

 

 

+7

 

 

 

 

 

 

+3

+10

 

 

 

JL AUDIO 250/1

 

 

+1

+13

 

 

 

 

 

 

 

 

 

 

monoblock subwoofer amplifier

 

 

 

 

 

 

 

 

Left Ch.

Right Ch.

LF Boost (dB)

Filter Freq. (Hz)

Left Ch.

Right Ch.

The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for even more detailed information about installing and tuning this amplifier.

M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T

A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.

Front Speaker Size / Location: 10-inches / Front Doors

*Fits JL Audio Models: TR650CSi, TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi & ZR650-CSi *Speakers require custom adaptors for installation.

Rear Speaker Size / Location: 5.25-inches / Behind Seats

C O N G R A T U L A T I O N S

You have completed the installation for this model!

Please refer to the Power Recommendation section for an amplifier recommendation and basic set-up help.

*Fits JL Audio Models: TR525-CXi, VR525-CXi & XR525-CXi

*Installation of Stealthbox® prevents installation of rear speakers

(954) 443-1100

www.jlaudio.com

 

 

All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.

JLA-SKU#011225-12-19-2006• Printed in USA • ©2005 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending. For more detailed information please visit us online at www.jlaudio.com.

Page 3 • JL Audio, Inc 2006

1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A

Page 3
Image 3
JL Audio SB-GM-C6CONV/8W3v3 warranty C L U D E D H a R D W a R E, Specification S, W E R R E C O M M E N D a T I O N

SB-GM-C6CONV/8W3v3 specifications

The JL Audio SB-GM-C6CONV/8W3v3 is a premium subwoofer enclosure meticulously designed for Chevrolet and GMC 2004-2015 Colorado, Canyon, and S10 models. This high-performance product combines outstanding craftsmanship with advanced acoustical design, delivering exceptional bass output that enhances the overall audio experience in your vehicle.

One of the key features of the SB-GM-C6CONV/8W3v3 is its compatibility with the 8W3v3 subwoofer, renowned for its remarkable performance capabilities. The subwoofer offers a high motor strength, delivering deep, precise bass with minimal distortion. The optimized enclosure utilizes JL Audio's extensive engineering expertise to create a configuration that maximizes the 8W3v3's potential, resulting in improved sound quality and efficiency.

The enclosure is constructed from high-quality MDF (Medium-Density Fiberboard), which is known for its rigidity and acoustical properties. Its sturdy construction minimizes vibrations that can interfere with sound production, ensuring that the bass notes remain tight and well-defined. Moreover, the enclosure is finished with a durable black carpet that complements most vehicle interiors while protecting the unit from wear and tear.

Technologically, the SB-GM-C6CONV/8W3v3 features a unique design that allows for easy installation. JL Audio has engineered a precise fit that can be seamlessly integrated into the vehicle’s existing architecture, without having to compromise passenger space. This enclosure is designed to be mounted behind the rear seat, optimizing the use of available space while delivering robust sound performance.

Another important characteristic is its power handling capability. The enclosure is capable of handling up to 600 watts of peak power, allowing the 8W3v3 subwoofer to perform at its best under demanding conditions. This ensures that even the most intense musical tracks are delivered with impactful bass response.

The SB-GM-C6CONV/8W3v3's overall design not only enhances audio performance but also caters to user-friendly installation. It comes with all the necessary terminals for straightforward setup, making it an ideal choice for both enthusiasts and casual listeners seeking an upgrade to their sound system.

In summary, the JL Audio SB-GM-C6CONV/8W3v3 is a high-quality subwoofer enclosure that exemplifies premium audio engineering, impressive power handling, and excellent fitment for select Chevy and GMC models. With its superior design and technology, this product stands out as an extraordinary choice for any car audio aficionado looking to elevate their listening experience.