JL Audio SB-N-TTNCRW/10W3v2/TN2 manual Run and attach speaker wire from, Nut in this order

Cont.

From

Previous

Page STEALTHBOX WALL

➔➔

FENDER WASHER

FLAT WASHER

LOCK WASHER

HEX NUT

THREADED INSERT

➔CONGRATULATIONS! INSTALL COMPLETE.

VEHICLE SHEET METAL

SOCKET CUP SET SCREW

STEP 7: Run and attach speaker wire from the	STEP 8: With the socket cup set screws protrud-
amplifier location to the enclosure.	ing through the floor of the vehicle. Place the sup-
	plied fender washer, flat washer, lock washer and hex
	nut in this order.
	Secure tightly.

Included Hardware:

1)Wax Square

1)3/8” x 2-1/4” Fender Washer

1)3/8” Flat Washer

1)3/8” Split Lock Washer

1)3/8”-16 Hex Nut

1)3/8”-16 x 2-1/4” Socket Cup Screw

Difficulty Of Installation:

Specifications:

Enclosure Type: Sealed

Driver Type: 2) 10W3v2-D4

Nominal Impedance: 4Ω

Cont. Power Handling: 600Watts

JL Audio recommends using a high quality amplifier such as the JL Audio 500/1. The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1 when being used to power your Stealthbox®.

Preamp Output Section		Infrasonic Filter	"Q"	Center Freq.		Boost (dB)		Amp LP Filter	Amplifier Input Section	Subwoofer Output
Output Mode	Filter Slope		1.6		45		+10	Mode / Slope	Input Voltage Input Sens. Signal Sensing
		1.1	2.7	35	55	+4	+13

0.7 25 70

Full Range / Amp Filter / Out Filter	12dB / 24dB	Off / 30Hz	4.3	20	85	0	Off / 12dB / 24dB	Low / High	Off / On
		0.5					+15

+12VDC Ground Remote	65		Filter Mode		30	Bass EQ			65	+	+	_	_
	55	85		25	40		Advanced	55	85
	45	120		18	50			45	120
JL AUDIO 500/1							Bass
	40	200	LP / HP	15	60	Off / On	Control	40	200	MONO OUTPUT ONLY
five-channel system amplifier

Left Ch. Right Ch. Filter Freq. (Hz) Infrasonic Freq. (Hz) Remote Bass Port Filter Freq. (Hz) Left Ch. Right Ch.

The JL Audio 500/1 is a very versatile audio component. Please consult the owner’s manual for detailed information about installing and tuning this amplifier.

Mid/High Frequency Driver Information:

Dash Location Driver Size:

2.5”	VR075-CT
Applicable JL Audio Products:
TR050-CT,VR075-CT, XR100-CT
*mounting plate is needed
Front Location Driver Size:
6” x 9”
Applicable JL Audio Products:	VR690-CXi
TR690-TXi,VR690-CXi
*mounting plate is needed
Rear Location Driver Size:
6.5” separates
Applicable JL Audio Products:	VR650-CSi
TR,VR, XR, ZR 650-CSi
*mounting plate is needed

10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111

w w w . j l a u d i o . c o m

SB - T- TTNCRW/10W3v2, JL AUDIO, Inc 2004 Pag e 2 Sheet SKU#01192 Revision 10/9/2004