JL Audio SB-VW-JETSW/10W3v3 C L U D E D H a R D W a R E, Specification S, N n e c t i o n s

			SB-VW-JETSW/10W3v3 INSTR_SKU# 94482
I N C L U D E D H A R D W A R E
3)	3/8” Split Lock Washer	3)	3/8 x 1-1/4” Fender Washer
1) 1/2” x 1”OD Spacer		2) 1” x 1”OD Spacer
3)	3/8-16 x 2-1/4” Set Screw	3)	3/8-16 Hex Nut

S P E C I F I C A T I O N S

Enclosure Type: Acoustic Suspension (sealed)

Driver Type: 10W3v3-4

Nominal Impedance: 4 Ohms

Continuous Power Handling: 500Watts

P o w e r R e c o m m e n d a t i o n

JL Audio recommends high quality amplifiers such as the JL Audio HD900/5, 500/1v2 or J2 500.1. The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1v2. If another amplifier is being used, please reference this illustration and use similar settings on that amplifier.

+12VDC Ground Remote

500/1v2

Monoblock Subwoofer Amplifier

Preamp Output Section

Output Mode	Filter Slope
Full Range Amp Filter Out Filter	12dB 24dB
		65	Filter Mode
	55	80
	45	100
	40	200	LP HP
Left Output Right Output	Filter Freq. (Hz)

Infrasonic Filter “Q” Center Freq. Boost (dB) Amp LP Filter Amplifier Input Section

Mode		1.6		40		+10		Mode Slope		Input Voltage	Input Sens.	Signal Sensing
		1.1	2.7	30	60	+4	+13
		0.7		25	75
Off On		0.5	4.3	20	80	0	+15	Off 12dB 24dB		Low High		Off On
30		Bass EQ							65
22	45					Advanced		55	80
18	55					Bass		45	100
15	60	Off On				Control		40	200
Infrasonic Freq. (Hz)			Remote Bass Port					Filter Freq. (Hz)		Left Ch.	Right Ch.

Subwoofer Output

MONO OUTPUT ONLY

All JL Audio amplifiers are very versatile audio components. Please consult the owner’s manual for even more detailed information about installing and tuning your amplifier.

C o n n e c t i o n s

Using quality power, signal and speaker wire is essential in ensuring the performance of your Stealthbox®.

JL Audio recommends using a 4 AWG power kit such as the XD-PCS4-1B for your Stealthbox® amplifier, other kits are available should you be using more than one amplifier. Signal wire such as the JL Audio Premium Audio Interconnect Cables should be used that will provide signal for both channels of the amplifier. JL Audio reccommends using 12AWG speaker wire for subwoofers such as our XD-BCS12-25.

M I D / H I G H F r e q u e n c y D r i v e r F I T M E N T

A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.

Front Speaker Size / Location: 4”- Front Doors

Fits JL Audio Models: TR400-CXi

Rear Speaker Size / Location: 6.5”- Rear Door

Fits JL Audio Models: TR650-CXi, TR650-CSi, C2-650x, C2-650, C3-650,

C5-650, C5-650x & ZR650-CSi

(954) 443-1100 www.jlaudio.com

All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.

JLA-SKU# 011308 06.21.2010 • Printed in USA • ©2010 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending. For more detailed information please visit us online at www.jlaudio.com.

Page 3• JL Audio, Inc 2009

1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A