JL Audio XD700/5 owner manual Appendix a, Necessary Equipment, Nine-Step Procedure

APPENDIX A:

Input Sensitivity Level Setting Following the directions below will allow the

installer to adjust the input sensitivity of each amplifier channel pair simply and easily in just a few minutes using equipment which is commonly available in installation bays.

Necessary Equipment

•Digital AC Voltmeter

•CD with a sine-wave test tone recorded at

0 dB reference level in the frequency range to be amplified for that set of channels

(50 Hz for subwoofer channels, 1 kHz for a midrange application). Do not use attenuated test tones (-10 dB, -20 dB, etc.).

The Nine-Step Procedure

1)Disconnect the speaker(s) from the amplifier’s speaker output connectors.

2)Turn off all processing (bass/treble, loudness, EQ, etc.) on the source unit, processors (if used) and amplifier. Set fader control to center position and subwoofer level control to 3/4 of maximum (if used to feed the XD700/5).

3)Turn all three “Input Sens.” controls all the way down.

4)Set the source unit volume to 3/4 of full volume. This will allow for reasonable gain overlap with moderate clipping at full volume.

5)Using the chart on this page, determine the target voltage for input sensitivity adjustment according to the nominal impedance of the speaker system connected to the amplifier outputs.

6)Verify that you have disconnected the speakers before proceeding. Play a track with an appropriate sine wave (within the frequency range to be amplified by the channel you are adjusting) at 3/4 source unit volume.

7)Connect the AC voltmeter to the speaker output connectors of the amplifier. If the channel pair is operating in stereo, it is only necessary to measure one channel. If bridged, make sure you test the voltage at the correct connectors (L+ and R–).

8)Increase the “Input Sens.” control until the target voltage is observed with the voltmeter.

9)Once you have adjusted each channel sectio of the XD700/5 to its maximum low-distortion output level, reconnect the speaker(s).

The “Input Sens.” controls can now be adjusted downward if the amplifier requires attenuation to achieve the desired system balance.

Do not increase any “Input Sens.” setting for any amplifier channel or channel pair in the system beyond the maximum level established during this procedure. Doing so will result in audible distortion and possible speaker damage.

It will be necessary to readjust the “Input Sens.” for the affected channels if any equalizer boost is activated after setting the “Input Sens.” with this procedure. This applies to any EQ boost circuit, including source unit tone controls or EQ circuits. EQ cuts will not require re-adjustment.

Nom.		Target AC Voltage
	Main CH	Main CH	Subwoofer
Impedance
	(Stereo)	(Bridged)	CH
8Ω	17.4 V	34.8 V	24.5 V
6Ω	17.4 V	32.8 V	24.5 V
4Ω	17.4 V	28.2 V	24.5 V
3Ω	16.4 V	not recommended	26.9 V
2Ω	14.1 V	not recommended	26.8 V

14 JL Audio - XD700/5 Owner’s Manual