XR650-CXi SPECIFICATIONS:

Woofers: Mineral-filled polypropylene cone body, 1-inch (25mm) voice coil, low-profile/symmetrical- roll spider, butyl rubber surround.

Tweeters: 1-inch (25 mm) aluminum dome tweeter with rubber surround, neodymium magnet, ferrofluid cooled and damped.

Adjustable tweeter angle.

Crossover Networks: 2-way network with 1st order low-pass circuit and 2nd order high pass circuit. Premium Mylar Capacitors and Air-Core inductors. 3-position adjustable tweeter output level. 3-position midrange presence control. Polyswitch™ tweeter protection.

Continuous Power Handling:

70 Watts (RMS Method)

Frequency Response: 48 Hz - 25 KHz (± 3 dB)

Efficiency @ 1W/1m: 89.5 dB

Nominal Impedance: 4 ohms

Included Components and Parts:

Two XR650-CXi 6.50-inch (160 mm) Coaxial Speakers

Two XR650-CXpxo 2-Way Crossover Networks

Two Metal Woofer Grilles and Grille Trays

Butyl Adhesive Putty for woofer grilles

Twelve #8 x 1 1/4 inch (30 mm)

Sheet Metal Screws

Eight Mounting Clips

Twelve Crimpable Fork Terminals

Four Black Nylon Wire Ties

Four 5-ft. (1.5 m) lengths of paired speaker wire with female clips

GETTING STARTED:

Turn off the audio system. It is also advisable to disconnect the negative (-) terminal of your vehicle’s battery whenever performing installation work.

Before cutting, drilling or inserting any screw, check clearances on both sides of the planned mounting surface. Also check for any potential obstacles, such as window tracks and motors, wiring harnesses, etc. Check both sides of the car, many cars are not symmetrical!

Always wear protective eyewear.

WARNING!

It is absolutely vital that your component system is connected as shown in Diagram A below. Failure to connect the system as shown will result in damage to your speakers which is NOT covered under warranty. Do not substitute different crossover networks into your XR650-CXi System. Only use crossover networks clearly marked “XR650-CXpxo”.

A) Wiring Diagram:

large terminal: (+)

small terminal: (–)

2

JL AUDIO XR650-CXi