CROSSOVER NETWORK
INSTALLATION:
The crossover networks supplied with your
Doors often get wet on the inside, which can damage your crossover networks and could potentially damage your entire sound system.
The crossovers can be screwed into a solid surface via two holes located under the protective cover of the case. To access these holes, simply squeeze the sides of the cover while gently pulling the cover away from the base. Make sure that your mounting location will not cause damage to wiring, fuel lines, brake lines or any other vital component of your vehicle. Once you have screwed the case in, snap the protective cover back into place.
If screwing the crossovers networks in is not possible, you can also run the supplied nylon wire ties through the mounting holes to attach the crossovers to a structure in your car. To do so, take the covers off, attach the wire ties, and then snap the covers back into place, lining the wire ties up with the slots on the sides of the protective cover. Make sure that you do not attach the crossovers to a moving part or to any part that may interfere with pedal operation, gear shift operation, steering, or airbag deployment.
For crossover network wiring instructions,
refer to the diagram on pages 2 & 3 of this manual.
6 | JL AUDIO |