JobSite Systems manual Package Contents, A45-X2x Removable AC power cord, Turn-Onmodes, Figure

PACKAGE CONTENTS

■A45-X2 x 1

■Removable AC power cord x 1

PREPARING FOR

INSTALLATION

Placement

Place the A45-X2 on a flat level surface like a table or shelf. It should be placed upright so that its weight rests on the four attached feet. Placing the weight of the amplifier on the rear or front panel may result in damage to the amplifier's connectors and controls.

The A45-X2, like any hi-fi component, will last much longer if it is given adequate ventilation for proper cooling. When installing the A45-X2 in a cabinet, be sure that the rear of the cabinet is open to fresh air to provide proper cooling. See Figure 2. If the cabinet’s design will not

accommodate an open rear, install two small “boxer fans” to provide continuous airflow into and out of the cabinet. See Figure 3. Place the A45-X2 so that there is at least 5" of free air space above the chassis. If the amplifier is located on a carpeted surface, place a board under the amplifier's feet. Do not block the ventilation holes on the top and bottom of the A45-X2.

If the cabinet rear is not open to fresh air, install two small “boxer fans” (55cfm fan) to provide continuous air flow into and out of the cabinet.

Figure 3

Make sure that there is a minimum of 5" of free air space above the amplifier for proper ventilation.

Allow a minimum of 5" of depth behind unit to accommodate cables and connectors.

Figure 2

TURN-ON MODES

The Turn-On Mode selector switch gives you three options for turning the A45-X2 on and off.

Slide the switch with your fingernail or a 1/8" slotted screwdriver blade.

4