JobSite Systems LSC-5/5R manual Painting the Speakers, Painting the Grilles, Frequency response

Painting the Speakers:

The speakers must be masked prior to painting them. The inside circular portion of the hole template can be used as a paint mask. Remove the outside portion of the template by gently pulling along the perforation. Affix the mask to the front of the speaker using a piece of tape. Fold the tape onto itself to form a double-sided loop. Affix the tape to the tweeter and place the mask onto the speaker.

Painting the Grilles:

The LSC-5/5R grilles should be painted before they are installed on the speakers. The best results will be obtained by using a spray gun or airless sprayer. Thin the paint, and then apply several light coats. This technique helps prevent clogging of grille holes. Paint both sides of the grille to cover all the white paint.

OPERATION

Listening at Higher Volumes:

It requires more power to achieve a reasonable volume of sound in a large room than it does in a small room. It is possible to turn the volume so high that the amplifier runs out of power. This creates “clipping” distortion.

Clipping distortion makes treble sound very harsh and unmusical. When you hear harsh sounding treble from any good speaker, turn the volume down immediately! You are much less likely to damage a speaker with a large amplifier because it will be very loud indeed before it produces any clipping distortion.

SPECIFICATIONS

LSC-5/5R

Power handing:

3 – 50 watts

Frequency response:

80Hz-20kHz +/- 4dB

Impedance:

8 ohms

Dimensions:

7-3/4” outside frame diameter

6-1/2” diameter hole cutout

2-3/4” deep when installed in 1/2” drywall

Ceiling Bracket for New Construction:

JobSite NCB-5 (sold separately)

Warranty: 5 year limited

4