John Lewis JLBIDOS904 instruction manual Preparing Cabinet for Fitting of Oven, Things to Note

b)By connecting the appliance together with a hob directly to a cooker point(s). Having a double pole isolating switch with at least 3mm contact separation in all poles and neutral.

c)If you wish to connect an oven and a hob to a cooker point you can by connecting the oven and hob separately to the cooker point. Oven and hob units should be separately connected to a cooker point. See Fig. 2.

NOTE: It is good practice to :

•Fit an Earth Leakage Circuit Breaker to your house wiring.

•Wire your appliance to the latest IEE regulations.

Things to Note

•This appliance is designed to be fitted in cabinets of the recommended dimensions as shown (Fig.3).

•If your cabinet interior dimension is between 565-570mm the oven may still be fitted. However, a minor modification to the cabinet will be required to reduce the aperture size down to 560-565 mm, to allow the product to be securely screwed into the cabinet.

•The dimensions given provide adequate air circulation around the unit within the cabinet, ensuring compliance with BS EN60-335.

•Enquiries regarding the installation of the cooker point, if required, should be made to your Regional Electricity Company to ensure compliance with their regulations.

•The appliance socket switch should be outside the cabinet but within 2m of the appliance to make it accessible to switch off the appliance in case of an emergency.

•To protect the hands, wear gloves when lifting the oven into its housing.

Do not lift the appliance by the handles.

Note: House Circuit

Earth leakage and continuity tests must be carried out before the appliance is connected to the mains supply and re-checked after fitting.

Connection	Min. size	Cable/flex	Fuse
via	Cable/flex	type
• Cooker	6mm2	PVC/PVC	35 A
Control		twin and	(min)
Circuit		earth

6

Fig. 2

Preparing Cabinet for Fitting of Oven

•Make sure that the cabinet is the correct size for the appliance to be fitted (Ref. Fig. 3).

•If the size is between 565-570mm, then the cabinet should be modified so that at the screw fixing points the recommended dimension of at least 560-565mm is maintained. The modification should ideally be localised to ensure that after screw fitment the oven is securely fixed into position.

•The cabinet must be stable and level by firmly securing it to the wall or floor. If necessary, make arrangements to ensure the shelf upon which the oven will rest is level.

•When the appliance is installed ensure a minimum gap of 2mm is maintained between the trim on the bottom edge of the appliance, and any corresponding door / panel underneath.