John Lewis JLBIGH702 Building over a kitchen unit with door, Fitting the Hob into the worktop

Building In

IMPORTANT: This hob must be installed according to the instruction supplied, and by qualified and competent personnel to the relevant National Standards.

Please ensure that when the hob is installed it is easily accessible for the engineer in the event of a breakdown.

Building over a kitchen unit with door

Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in diagram 3.

The panel fitted under the hob ("a") should be easily removable to allow easy access if technical assistance is needed.The space behind the kitchen unit ("b") can be used for connections.

Building over a cupboard or drawer

If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface.

It is also recommended to carry out the electrical connection to the hob as shown in diagrams 1 and 2.

Dimensions are given in mm

1	ON/OFF SWITCH
FLEX
OUTLET
	FO
FO 2563	2564

ON/OFF SWITCH	2
FLEX
OUTLET

Fitting the Hob into the worktop			3
Carry out the building in of the hob as follows:
￿	• put the seals supplied with the hob, on the edges of the cut out like shown in
		the fig. 4, taking care that the seals meet without overlapping;
	•	place the hob in the cut out, taking care that it is centred;
	• fix the hob with the relevant fixing clamps and screws, as shown in the diagram
		5.When the screws have been tightened, the excess seal can be removed.
The edge of the hob forms a double seal which prevents the penetration of liquids.
		4
			FO 2044
		5
			Seal
			a
			FO 0199
			11