John Lewis JLBIWD 1400 Automatic Dry button, Time dry button, Delay start button

•“Quick”: select this option for laundry that is only slightly soiled in order to obtain a good wash result in a short time.

This option is not available with the Wool programmes, the Energy saving programmes “Economy” and “30 Minute wash”.

The washing time will be reduced according to the type of fabric and the selected temperature.

•“Extra rinse”: this option can be selected with all programmes, except the Wool programmes and “30 Minute wash”. The machine add 2 rinses for cotton and 1 rinse for synthetics and delicates.

This option is recommended for people who are allergic to detergents, and areas where the water is very soft.

6 “Automatic Dry” button

This button allows you to choose the required degree of drying for cottons and synthetics:

-Extra dry (only for cottons)

-Store dry (cottons and synthetics)

-Iron dry (only for cottons)

The drying time is automatically adjusted by the machine: the laundry will be dried to the selected degree of dryness.

7 “ Time dry” button

If you wish to carry out a timed programme instead of an electronic programme push the button until the drying time you want appears in the display according to the fabrics (cotton or synthetics) you have to dry.

For Cottons and Synthetics you can select a drying time from 10 minutes to 130 minutes.

8 “Delay start” button

This button makes it possible to delay the starting of the programme 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 23 hours.

The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears.

You must select this option after you have set the programme and before you press the “Start/Pause” button.

The time value shown on the display will decrease by one unit every hour.

You can change the delay time at any moment, before you press the “Start/Pause” button.

If you have already pressed the “Start/Pause” button, and you wish to cancel the delay time, proceed as follows:

•set the machine to PAUSE by pressing the “Start/Pause” button;

•press the “Delay start” button until the symbol “0’ ” is displayed.

•press the “Start/Pause” button again.

Important!

•The “Delay start” cannot be used with “Drain” or “Spin” programmes.

Note!

•With programme “Soak 30°” the selected delay (up to a maximum of 10 hours) corresponds to the soak time of the laundry in the drum.

•The door will be locked throughout the delay time. If you need to open the door, you must first set the washer-dryer to Pause by pressing the “Start/Pause” button. After you have closed the door, press the “Start/Pause” button again.

9 “Start/Pause” button

This button has two functions:

•Start: after you have selected the desired programme and options, press this button to start the washer- dryer. The light above the button will stop flashing and remain lit.

If you have selected a delay time, the countdown will begin and will be shown on the display.

•Pause: when you press this button again, the programme in progress is interrupted. The light above the button will start flashing. To restart the programme from the point at which it was interrupted, press the button again.

Important!

You must set the washer-dryer to Pause before you make any change in the programme in progress.

10 Display (Programme time)

The following pieces of information are shown on the display:

•Reset/cancellation of the programme

If the programme selector dial is turned to “Off” position, three blinking dashes are displayed. Now you can select a new programme.

15