John Lewis JLBIWM1401 Control Panel, Detergent dispenser drawer Mains-on light, On/Off button

The Control Panel

				Programme time
	1400						Prewash
	900						Wash
	700						Rinse
	500						Rinse hold
	Rinse hold						Drain
		Extra			Delay	Start/	Spin
On /Off	Spin Prewash Quick	rinse	Stain	Quiet	start	Pause	Filter
							End	Wool

JLBIWM1401

	2		4		11
1		3		5	6 7 8 910

30 Minute wash	Off
Spin
Drain
Softeners
Rinse
Soak 30°
Cold
30°
40°
Delicates 30°
Delicates 40°

12

95° Economy 60° 60°

Economy 40° 40°

30° Cold 60°

Economy 40° 40° Easy iron 40° Cold

SyntheticsCottons

1 Detergent dispenser drawer

2 Mains-on light

This light comes on when the “On/Off” button is pressed, and goes out when it is pressed again.

3 “On/Off” button

Press this button to switch the machine on. Press it again to switch the machine off.

4 “Spin” button

Press this button repeatedly to change the spin speed, if you want your laundry to be spun at a speed different from the one proposed by the washing machine or to select position “Rinse hold”. The relevant light will light up.

Spin speed

The following speeds are available for the different fabrics:

•Cottons, linen:

500/700/900 max 1400 r.p.m.;

•Synthetics and Wool: 500/700 max 900 r.p.m.;

•Delicates and “30 Minute wash”: 500/ max 700 r.p.m.

“Rinse hold” position

When Rinse hold option is selected, the last rinse water is not emptied out, to prevent the fabrics from creasing. When the programme has finished, the light of the “Start/Pause” button goes out, the light of the “Rinse hold” position and the “End” pilot light are alight to indicate that the water must be emptied out. The display shows a flashing zero. The door is locked.

To empty out water there are 2 possibilities:

•Select programme “Drain” and then depress the “Start/Pause” button:

The water is emptied out without spinning.

•Select the Spin programme : reduce the spin speed by means of the relevant button and then depress the “Start/Pause” button.

The water is emptied out and the laundry is spun at the selected spin speed.

Important !

Before selecting the “Drain” or “Spin” programmes, the selector dial must be positioned on Off (cancelling).

5 “Option” buttons

Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before depressing the “Start/Pause” button.

When these buttons are pressed, the corresponding pilot lights illuminate. When they are pressed again, the pilot lights go out.

If an incorrect option is selected, the pilot lights flash for about 2 seconds, an acoustic signal is heard and the message Err is displayed.

Press these buttons to select the following options:

•“Prewash”: select this option if you wish your laundry to be prewashed at 30°C max. before the main wash (not available for Wool and “30 Minute wash”).

The prewash cycle ends with a short spin at 650 rpm in programmes for cotton and synthetic fabrics, whereas in the programme for delicate fabrics the water is only drained. This option can be selected for heavily soiled laundry but not together with “Stain” option.

15