Unpacking
Remove all packaging before positioning the appliance.
Remove the transport supports placed along the door sides.
Some models are fitted with a silencing pad under the freezer. Do not remove this pad.
Installing the freezer
When two appliances are placed beside each other, the spacers enclosed in the plastic wrapping should be glued between the appliances. As shown in the illustration.
Make sure that the power plug is not squashed or damaged by back of the product.
DA damaged power plug may overheat and cause a fire.
Do not place heavy articles or the product itself on the power cord.
Dthere is a risk of a short circuit and fire.
If the power plug socket is loose, do not insert the power plug.
Dthere is a risk of electric shock or fire.
To obtain the best performance from the freezer, ensure :
Dthe freezer is placed in a dry, cool place and is not exposed to direct sunlight.
Dthe freezer is not placed close to a source of heat, e.g. a
cooker or dishwasher.
Dthe freezer is level. The freezer should not leanagainst any wall. If necessary adjust the feet using the
adjustment spanner supplied.
Dthere is good air circulation around the freezer and that the air channels below and behind the freezer are not blocked. The ventilation space between the freezer and a cupboard above must be at least 40mm.
The ventilation space can either be
a)directly above the freezer, or
b)If a cupboard is placed immediately above the freezer there should be a ventilation gap behind the cupboard of 50mm deep and at least a 40mm gap between the top of the cupboard and the ceiling.
If the freezer is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the freezer must be at least 15 mm to allow the door to open enough so that the baskets can be removed.
The power plug must be accessible after installation of the freezer.
a) | b) | 50mm |
7
