John Lewis JLFFW1807, JLSS1808 Unpacking, Cleaning, Positioning, Climate Classification

Models: JLFFW1807 JLSS1808

1 24
Download 24 pages 37.18 Kb
Page 7
Image 7
Unpacking

Unpacking

The appliance must always be transported in the upright position as indicated on the outside of the

packaging.

After each transportation the appliance must not be switched on for approx. 2 hours. to ensure the coolant gases settle.

Unpack the Fridge Freezer and check for any possible damage. If the appliance is damaged please report this to the John Lewis branch from which you purchased; in this case please retain the packaging.

Cleaning

Remove all adhesive tape and ties, which ensure the internal fittings do not move during transportation.

Wash the inside of the appliance using lukewarm water and mild detergent; using a soft cloth.

Further cleaning advice is given on page 19.

Positioning

The appliance should be located in a well ventilated, dry room.To ensure correct operation the appliance should:

Not be exposed to direct sunlight.

Not be installed next to radiators, cookers or other sources of heat.

Only be installed in a location where the ambient temperature corresponds to the climate classification for which the appliance is designed.

Climate Classification

The climate classification can be found on the rating plate; which is located on the bottom left hand side of the fridge compartment, see page 5 .

The table shows the correct operating ambient temperature for each climate class.

Class of climate

Ambient temperature

SN

+10…+32°C

N

+16…+32°C

ST

+18…+38°C

If the temperature rises above or falls below the stated ambient temperature for the climate class, the operation of the appliance may be affected.

Ventilation

You should ensure that air can circulate freely around the back and top of the cabinet. In the Instruction manual bag there are two spacers which must be fitted to the top rear corners. This will ensure a gap is maintained between the Fridge Freezer and the wall.

Loosen the screws and insert the spacer under the screw head, then re-tighten the screws.

Levelling

When placing the appliance ensure that it stands level, to prevent vibration, excessive noise and to ensure the doors shut correctly.

Level the appliance by turning the 2 adjustable feet at the front of the Fridge Freezer.

When placing the refrigerator keep minimal distances recommended in figure.

A:placing it under a wall-cupboard

B:placing it freely

7

Page 7
Image 7
John Lewis JLFFW1807, JLSS1808 instruction manual Unpacking, Cleaning, Positioning, Climate Classification