John Lewis JLTDC01 instruction manual Changing a programme, Switch off the appliance, Crease guard

Changing a programme

To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF and then reset the programme.

The programme can no longer be changed directly once the programme has started. If nevertheless there is an attempt to change the programme on the programme selector, the programme progress display and the maintenance indicators flash. If an option button (excluding the SIGNAL button) is pressed, Err appears in the multidisplay. The drying pro- gramme is not however affected by this (laundry protec- tion).

Switch off the appliance

To switch off the appliance at the end of the drying cycle, turn the programme selector to OFF.

8 Programme progress display

The lights indicate the different phases of the drying cycle. Drying:

The light indicates the drying phase. Cooling:

The light indicates a cooling phase of 10 minutes. End:

The light indicates the end of the cooling phase and the end of the programme.

Crease guard:

The drying cycles (except for the WOOL programme) are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti- crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming.)

9 Display

The display shows the following information:

•Duration of the selected programme

•Delayed start

•End of programme

•Incorrect selection of programme options

•Error code

10 Delay start button

By pressing the DELAY START button, the start of a pro- gramme can be delayed by between 30 minutes (30') and a maximum of 23 hours (23h).

This option must be selected after having selected the pro- gramme and before pressing START/PAUSE to start the pro- gramme.

Every time the button is pressed, the time is increased by 30 minutes until the display shows a delay of 2 hours. After this, the delay is displayed hour by hour.

If 23h is displayed and you press the button again, the time delay will be cancelled. The display will show 0' and then the duration of the selected programme.

To activate the count down, the START/PAUSE button has to be pressed. The amount of time remaining until the pro- gramme is set to start is continuously displayed (e.g. 12h, 11h, 10h, … 30' etc).

During the delayed start, it is not possible to change the programme or the delay time selected. To do this, you must first switch off the appliance by setting the programme se- lector to OFF.

If you wish to add more laundry while the countdown is running, simply open the door. When you close the door, press the START/PAUSE button again to cause the count down to be resumed.

11 Intensity button

For precise setting of the residual moisture content of the laundry, the degrees of dryness +, ++ or +++ can be set in addition to most programmes. Laundry becomes drier from + to +++.

The INTENSITY button must be pressed repeatedly until the light for the residual moisture required is lit.

In the programmes WOOL or SILK further drying can also be set by restarting the programmes with the residual mois- ture levels +, ++ or +++ set in addition, as required. In the case of a drying cycle with relatively dry laundry, the length of the programme cycle displayed at the beginning is cor- rected after a while.

Important: Do not over dry wool or silk.

12 Level of dryness

Depending on the selected programme the lights indicate the level of dryness reached while the drying cycle is run- ning. The level of dryness increases from IRON DRY to EX-

TRA DRY.

11