John Lewis JLTDC06 Procedure, Adjusting the level of conductivity, Memorising the new setting

Adjusting the level of conductivity

Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to geographical locations thus varying its conductivity values.

Relevant variations of the conductivity of the water compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle.

Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the water by using the following procedure.

To establish the hardness of your water to correspond with the table opposite please contact your local water authority.

Procedure:

Turn the programme selector dial to switch on the appliance

In selection mode press simultaneously the buttons 3 and 6 until «C0» appears on the digits.

Rack dry	Off	Extra dry	Cottons
Wool		Store dry						Dry time		Drying
Extra delicate		Cupboard dry						1.25		Cooling
Easy iron		Damp dry								End
Refresh		Iron dry
					Alarm		Half	Delay	Start/
30 minutes		Extra damp		Door		Quick				Filter
					off		power	start	Pause	Full tank
		Extra dry		1	2	3	4	5	6
			Synthetics							Condenser
		Cupboard dry
										JLTDC06
		Iron dry

Adjusting the level of conductivity:

Press the button 5 sequentially: the level of conductivity is indicated by the lighting of the horizontal hyphens.

				Dry time		Drying
						Cooling
						End
Door	Alarm	Quick	Half	Delay	Start/	Filter
	off		power	start	Pause	Full tank
1	2	3	4	5	6
						Condenser
						JLTDC06

Display	Conductivity	Approximative
	degree	value (µS/cm)
C 0	Low	< 300
C 0	Medium	300 - 600
C 0	High	> 600

Memorising the new setting:

Simultaneously press down the buttons 3 and 6 until the previous drying cycle time appears again on the display and the buzzer sounds.

19