Using the tumble dryer
Before using your tumble dryer for the first time, we recommend that you to place a few damp cloths inside the appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1.Connect the appliance.
2.Open the door (see picture).
The END, FILTER and FULL TANK lights remain lit and the buzzer sounds every 10 seconds for 2 minutes.
The light of the START/PAUSE button goes off and a flashing zero appears on the display.
10. Turn the programme selector dial to “Off”; all the |
lights go out. The appliance is switched off. |
Remove the laundry. |
If you open and then close the door before |
P1149 |
P1108 |
turning the programme selector dial to |
“Off”, all the lights corresponding to the |
phases making up the performed |
programme come on and the display shows |
the duration of the programme. |
After each use
• | Clean the filters (see page 17). |
• | Empty the water reservoir (see page 18). |
3.Load the items one at a time, shaking them out loosely.
4.Close the door. Please check the laundry does not get caught between the door and filter.
5.Select the drying programme or time. The lights DRYING, COOLING and END come on. The light of the START/PAUSE button flashes and the display shows the duration of the programme.
6.If required, press the HALF POWER button and/or the ALARM OFF button or the QUICK button.
7.Select the DELAY START if required. The selected delay appears on the display for 2 seconds, then the duration of the selected programme is displayed.
Removing laundry or loading laundry when necessary
1.Open loading door
Warning!
Laundryanddrumcanbecomehot.Riskof burns!
2.Load or remove laundry items.
3.Close the door securely. Lock must audibly lock.
8.Press the START/PAUSE button: the corresponding light stops flashing and drying starts. Only the DRYING light stays lit. If you have selected the DELAY START, the machine begins its countdown.
If the programme selector dial is turned to another position, when the machine is running, the buzzer will sound, the programme phase indicator lights will flash.
The drum turns alternately in both directions during drying.
All drying programmes end with a 10 minute cooling phase (COOLING light illuminates).
You may remove the laundry after this phase.
The lights END, FILTER and FULL TANK illuminate and the buzzer sounds.
The display shows a static zero.
9.If the laundry is not removed at the end of the cycle, the dryer performs an
If you do not remove the laundry, the dryer will stop automatically at the end of the
4.Press the START/PAUSE button to continue the drying cycle.
Modifying the programme
To change a programme which is running, first cancel it by turning the programme selector dial to “Off”. Select the new programme and press the START/PAUSE Button.
13
