Philips 51PW9363, 60PW9363, 55PW9363 manual Using the CODE-ENTRY Method to Program Your TV Remote

Using the Remote Control

USING THE CODE-ENTRY METHOD TO PROGRAM YOUR TV REMOTE

Now that you have looked up the four- digit remote-control Direct-entry Code

for your brand of accessory device, you are ready to follow the simple steps shown below to program your TV remote.

Please read through all the steps before beginning.

1 First, press and hold down the VCR or ACC (for an accessory device other than a VCR) mode button on the TV remote. Then press and hold down the MENU/SELECT button at the same time for a brief moment. Release the buttons. The TV remote back light will switch on.

NOTE: For correct operation, you must first press and hold the mode button and then press and hold the MENU/SELECT button simultaneously.

2 Within 30 seconds of pressing the VCR (or ACC) button and MENU/SELECT button, enter a four-digit code for the accessory device (see pages 21 and 22).

If you make a mistake while attempt- ing to enter the four-digit code and want to start again, press any button other than one with a number. Then return to step 1 to begin again.

3 Point the remote at the accessory device. Then press the POWER button on the remote to turn the device on.

HELPFUL HINTS

•If you do not enter a complete code within

30seconds, you will need to perform step

1of the Code-entry Method again.

•If you enter more than four digits, the unit will retain the first four digits entered.

•If the procedure explained above does not work the first time, repeat the steps using the same remote code number.

•If after a second try the remote does not operate your accessory device, and more code numbers are listed for your brand, use the next listed code number.

•If after repeated attempts the Entry-code Method does not allow you to work your accessory device with your TV remote, try the Search Method explained on the next page.

Satellite Receiver

Cable Converter Box

DVD Player

VCR

1		POWER
			3
TV	VCR	ACC
SWAP	PIP CH	ACTIVE
		CONTROL
DN	UP
SOUND		PICTURE	1
STATUS/		MENU/
EXIT		SELECT
2 VOL	MUTE
		CH

1 2 3

4 5 6

7 8 9

TV/VCR

A/CH	0	SURF
POSITION		PIP

19