Philips 51PW9363, 60PW9363, 55PW9363 manual Setting the TIMER’S Activate Control

Using the On-screen Submenus: Features

SETTING THE TIMER’S ACTIVATE CONTROL

After you have set the TIME, START TIME, STOP TIME, and CHANNEL,

you must activate the Timer for it to operate. Your options are to set the Timer to work ONCE or DAILY. Set ACTIVATE to OFF if you don’t want to use the Timer.

PICTURE	TIMER	FEATURES
SOUND	AutoLock			TIME
			TIMER
FEATURES	PIP
			AutoLock	START TIME
INSTALL	CLOSED CAP
			PIP	STOP TIME
	FORMAT
			CLOSED CAP	CHANNEL
			FORMAT	ACTIVATE

1 Press the MENU/SELECT button on the remote control to show the on-screen menu.

	Press the CURSOR RING DOWN				POWER		FEATURES
							TIMER
2 twice to highlight FEATURES.							START TIME	8:06 PM
							TIME
3	Press the CURSOR RING RIGHT				ACTIVE ACC	3,4,	STOP TIME
	to enter the FEATURES submenu.		TV	VCR			CHANNEL
	Press the CURSOR RING RIGHT		SWAP	PIP CH	CONTROL FREEZE	5	ACTIVATE
		6	DN	UP
	again. Then press the CURSOR		SOUND
4 RING DOWN repeatedly until the
	ACTIVATE control is highlighted.		STATUS/		MENU/		FEATURES
			EXIT		SELECT		TIMER
	Press the CURSOR RING RIGHT
							TIME
	to cycle through the options and
				MUTE			START TIME
5 make your selection. The options are			VOL		2	1	STOP TIME
	ONCE, DAILY, or OFF.						CHANNEL
							ACTIVATE	ONCE

6 Press the STATUS/EXIT button to exit the menu.

HELPFUL HINT

•Changing the channel or adjusting the volume during the last minute of a Timer setting will cancel the shutting off of the TV.

•Thirty seconds before the set changes to the channel you set (see page 42), an announcement appears on screen.

1	2	3
4	5	6
7	8	9	ACTIVATE
TV/VCR	0
A/CH		SURF
			ACTIVATE
	POSITION	PIP

OR

DAILY

OR

OFF

CHANGING TO CHANNEL 5 IN 29 SEC

43