Silvercrest KH 2155 Programming by manual code input

Repeat these operational steps for all devices that you would like to control with the remote control.

Programming by manual code input

In this mode the remote control can be programmed by direct input of a code number. Please extract the necessary code number from the accompanying code list. In the event that the new code is invalid the last valid programmed code will be restored.

1.Hold down the SET button e for a little longer than 3 seconds.

2.In the LCD display q appears "CODE SETUP". Press the OK button l. "BRAND SRCH" now appears in the LCD display q. Press the  or  button h until "CODE SET" is shown in the LCD display q. Then press the OK button l.

3.In the LCD display q appears the last programmed device and the code used.

4.Press the desired device button r (i.e. VCR). The target device now blinks and waits for your confirmation.

5.With the OK button l confirm the selected device. Now the first digit of the code blinks and waits for your code input.

6.Enter the 3 digit device code with the number buttons and confirm the entry with the OK button l.

7.If the entered code is valid for the selected device type then the code will be saved. In the LCD display q appears "SUCCESS" and then again "CODE SET". In the event of failure the LCD display q shows "NOT FOUND" and waits for a new code input. Then you repeat step 6.

8.For many combi-devices you must enter 2 codes from the accompanying list, i.e. one for the TV section and one for the DVD section. If the code of a combi-device (i.e. TV-DVD) is shown in the list as "XXX XXX" then apply the first 3 numbers for the device named first in the device denomination (=TV), and the last 3 numbers for the device named second (=DVD).

9.With the EXIT button j you can end the CODE SET mode.

- 13 -