Configuration
Setting the time
The LCD display q shows you the time of day. You set this as follows:
1.Hold down the SET button e for a little longer than 3 seconds.
2.With the or button h select "CONFIG" and confirm with the OK button l.
3.In the LCD display q appears "TIME SETUP". Confirm with the OK button l. The LCD display q now shows
"TIME" and the first number of the hour display blinks.
4.With or h place the cursor on the position, in which you want to make an entry and press the number buttons o to set the hour and minutes. The switching be- tween AM and PM you undertake with the or but- ton h. Thereby "AM" stands for "ante meridium"
(= morning, 0:00 to 12:00 o'clock) and "PM" stands for "post meridium" (= afternoon, 12:00 to 0:00 o'clock).
5.With the OK button l you save the setting. In the LCD display q appears "SUCCESS" and the previous mode is accessed again. In the event of an error the LCD display q shows "ERROR".
6.To exit this menu press repeatedly the EXIT button j until the standard display appears in the LCD display q.
Adjust contrast
You can set the display's contrast as follows:
1.Hold down the SET button e for a little longer than 3 seconds.
2.With the or button h select "CONFIG" and confirm with the OK button l.
3.With the or button h select "CONTRAST" and con- firm with the OK button l.
4.With the or h button you set the contrast ( reduces the contrast, increases the contrast). Display readout:
0 = highest contrast
15 = lowest contrast
5.With the OK button l you save the desired setting. In the LCD display q appears "SUCCESS" followed by "CONTRAST".
6.To exit this menu press repeatedly the EXIT button j until the standard display appears in the LCD display q.
- 9 -
