- 15 -
8. If the device does not react again carry on switching
every 1.5 seconds with the button h to the previous
code until the device reacts.
9. Then press the OK button l to save the code. The LCD
display q shows "SUCCESS" and then returns again to
the "AUTO SEARCH" mode.
10. Press the EXIT button j twice to exit the programming
mode.
11. Check to see if the majority of your device's functions
can be controlled with the remote control. In the event
that a few functions are not working you can start the
automatic code search again beginning with step 1.
Tips:
If the PAUSE ;button d is pressed during the automatic
code search the code search stops. Pressing on the PAUSE ;
button d again allows the device to take up the search once
more.
1. During an active code search all buttons except OK l,
PAUSE ; d, , h and EXIT j will be ignored.
2. If the EXIT button j is pressed during the code search
the search will stop and the "AUTO SRCH" status is
again accessed without the code being saved.
3. Should the correct code be found, however the device's
original remote control did not have a POWER button
then it is possible that the device cannot be switched on
ororemotely.Thentrythebuttons h, CH + y or
MUTE 2#.
4. If the automatic search has reached the end of the code
list it stops there. Then press the EXIT button j to return
to the "AUTO SRCH" mode and start again with step 4.
5. If you want to programme an AUX device by automatic
codesearchthedevicetypemustrstbedenedby
direct code input. After which you carry out the auto-
matic code search from step 5.
Learn function
The Universal remote control (URC) can learn and save button
signals of an original remote control. If the URC does not
work after applying the programming methods already
described or cannot carry out all commands please attempt
to teach the URC with the help of the original remote control.
Use new batteries for the URC and the original remote •
control.
Maintain a distance of at least one metre from other light •
sources. The light sources could disrupt the infrared trans-
mission.
Place the URC and the original remote control at a distance •
of 25 to 55 mm from each other on an even surface so that
the Infrared diodes 2^ are facing each other.