Tips:
1.Do not use the following buttons for the learn function: all device buttons r, LIGHT t, MACRO 2@, FAV.CH 2$, 
d, EXIT j.
2.When teaching please do not release the button of the original remote control until "SUCCESS" or "FAILED" appears in the LCD display q.
3.If whilst teaching when the display is showing "WAITING" still no button on the original remote control is pressed after 25 seconds the LCD display q shows "FAILED" followed by "SELECT KEY".
4.If the memory is full the LCD display q shows "MEM FULL" and the learn mode will end.
5.Whilst the LCD display q is showing "WAITING" in the learn mode the mode can only be ended with the EXIT button j.
6.During the learn mode or when the taught buttons are deleted the current mode can be exited with any button (except when "WAITING" is showing).
7.With the EXIT button j you return to the previous status.
Code learn function
1.Press the desired device button r.
2.Hold down the SET button e for a little longer than 3 seconds.
3.With the or button h select the menu "LEARNING" and then press the OK button l.
4.In the LCD display q appears "LEARN KEY". Then press the OK button l. In the LCD display q appears "SELECT KEY".
5.First press the button on the URC that is to be taught. In the LCD display q appears "WAITING". The URC now waits for the Infrared signal from the original remote control.
6.Point the Infrared sensors 2^ of both remote controls towards each other.
7.Now hold down the desired button of the original remote control until "SUCCESS" or "FAILED" appears in the display q of the URC.
8.If in the LCD display q "SUCCESS" appears (process successful), you can teach further buttons begining with step 5. If "FAILED" appears (process unsuccessful) repeat the process in any case from step 5.
9.To stop the learn process any device button r can be pressed. If in the LCD display q is shown "WAITING" then stopping can only be carried out with the EXIT j button. After which the URC again returns to the "LEARN KEY" mode (see step 4).
- 16 -
