Something Not Working

If the tumble dryer is not working correctly, please carry out the following checks before contacting your local Service Force agent.

IMPORTANT: if the END light flashes, the buzzer sounds and an alarm code is displayed, switch the machine off and call the telephone number given on page 21.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or nstallation a charge will be made even if the appliance is under guarantee.

Symptom

Solution

 

 

 

The tumble dryer does not start

The door(s) has (have) not been closed.

The plug is not properly inserted in the power socket.

 

 

There is no current at the socket.

 

The main fuse or the fuse in the plug has blown.

 

The selector dial is not set correctly.

 

The water reservoir is full or not properly inserted (the

 

 

FULL TANK light is on ). The programme starts in any

 

 

case but it stops after approx. 4 minutes.

 

The START/PAUSE Button has not been depressed.

 

The DELAY START option has been selected.

 

 

 

Drying takes too long or laundry is not

The laundry has not been spun properly.

dry enough.

The filters and/or the condenser are clogged.

 

The water reservoir is full.

 

• The room temperature is too high.

 

The selected time or drying cycle was not suitable for

 

 

the laundry.

 

• The HALF POWER button has been pressed.

 

There is too much laundry inside the appliance.

 

The dryer is not correctly installed.

 

 

 

The drum light does not light up:

The Programme/Time selector dial is on position “OFF”.

 

• The lamp is defective.

 

 

 

20

Page 20
Image 20
John Lewis JLTDC 07 Something Not Working, Tumble dryer does not start, Drying takes too long or laundry is not