Johnson Controls F) SERIES, YCJ(D Section Xi Start Up Sheet, Owner Information, Equipment Data

872678-UIM-C-0213

SECTION XI: START UP SHEET

Print Form

Air Conditioning and Heating Start-Up Sheet

Proper start-up is critical to customer comfort and equipment longevity

Reset Form

Start-Up Date

Technician Performing Start-Up

Installing Contractor Name

Owner Information

Name			Address
City		State or Province				Zip or Postal Code
Equipment Data	Upflow	Downflow			Horizontal Left		Horizontal Right
Indoor Unit Model #				Indoor Unit Serial #
Indoor Coil Model #				Indoor Coil Serial #
Outdoor Unit Model #				Outdoor Unit Serial #

Filter, Thermostat, Accessories

Filter Type

Thermostat Type

Filter Size Filter Location(s)

Other System Equipment and Accessories

Connections -- Per Installation Instructions and Local Codes

Unit is level	Supply plenum and return ducts are connected and sealed
	Gas piping is connected (if applicable)
	Condensate drain for indoor coil properly connected

Refrigerant piping complete and leak tested

Vent system is connected (if applicable)

Condensate drain for furnace (if applicable)

Electrical: Line Voltage

Indoor unit (volts AC)

Ground wire is connected

Outdoor unit (volts AC) Overcurrent Protection Breaker / Fuses Amperes

Polarity is correct (120vac indoor units) black is L1 (hot), white is N (neutral)

Electrical: Low Voltage	Thermostat wiring complete		Heat anticipator
Heat anticipator is set to the recommended value listed in the Installation Instructions			recommended value
Low voltage values: "R" and "C" at Indoor unit control board (volts AC)		"R" and "C" Outdoor unit control board (volts AC)
Heating Set-Up

Heating Type	Electric Air Handler	Natural Gas
Inlet Gas Pressure (in. w.c.")		Manifold Gas Pressure (in. w.c.")
Calculated input in btuh - clock the gas meter (Nat Gas Only)
Electric Heat Kit Part # (if applicable)			KW installed

LP Gas (Requires LP Conversion Kit) LP Gas Conversion Kit Part # Used

LP Kit Installed By

Rated BTU/H (furnaces)

Venting (if applicable)

Intake Size

Exhaust Size

Venting system properly sized, within the limitations of the charts in the installation instructions.

# of 90 Degree Ells	# 0f 45 Degree Ells	Length
# of 90 Degree Ells	# 0f 45 Degree Ells	Length
		Continued on next Page

Johnson Controls Unitary Products 17