ASSEMBLY
Fitting the blade guard/combination guard, grass blade and
•Hang the trimmer guard/combination guard (A) on the two hooks on the plate holder (M). Bend the guard around the shaft and tighten it with the bolt (L) on the opposite side of the shaft. Use the locking pin (C). Place the locking pin in the groove on the screw head and tighten. See diagram.
L
M
C
A
•CAUTION! Always use the recommended guard for the cutting attachment you are using. See chapter on Technical data.
•Fit the drive disc (B) on the angle gear’s output shaft.
•Centre the metal cup (P) on the drive disc’s blade guide.
•Turn the output shaft until one of the holes in the drive disk aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Position the blade (D) with the drive disk (B). Make sure that the blade is centered by fitting it to the guide on the drive disk.
•Fit the support flange (F) on the output shaft so that it rests against the blade.
gear housing to lock the drive disk. Hold the shaft of the socket spanner as close to the blade guard/combination guard as possible.
WARNING! Tighten the lock screw (N) in the
!center hole of the support cup. Tighten to a torque of
Fitting the blade guard and saw blade
CAUTION! Always use the recommended guard for the cutting attachment you are using. See chapter on Technical data.
FC2255, FC2255W
•The blade guard (A) is fitted using 4 screws (L) as shown.
L
D
N
E
F
P
B
A C
A
BC2255
• | Fit the holder (R) and bracket (J) with 2 bolts (H) on the |
| gear housing. |
• | Then fasten the blade guard (A) with 4 bolts (L) in the |
ML
•Screw the support cup (E) onto the output shaft threads (CAUTION!
holder (N). |
H
J
K | R |
|
A
L
•Fit the drive disc (B) on the output shaft.
14 – English
