ASSEMBLY

Adjusting the harness and clearing saw

!WARNING!

When working with the clearing saw it should always be hooked in the harness. If this is not done, you cannot control the clearing saw safely and this can result in injury to yourself or someone else. Never use a harness with a defective quick release catch.

Quick release

On the front is an easily accessible, quick release catch. This is activated by pulling the outer part of the chest plate straight out. Use this if the engine should catch fire or in any other emergency situation when you quickly need to take off the harness and machine.

Even load on the shoulders

A well-adjusted harness and clearing saw significantly facilitates working. Adjust the harness for the best working position. Tension the side straps so that the weight is evenly distributed across the shoulders.

Correct height

1) Forestry clearing Adjust the carrier strap so that the suspension hook comes approximately 10 cm under the hip. The blade should be angled forward a little.

2)Grass clearing

The suspension hook should hang approximately 20 cm under the hip so that the blade is parallel to the ground.

Correct balance 1)Forestry clearing

Move the suspension eye forwards or backwards. If the blade is balanced a 10- 20 cm above the ground it is easier to avoid stones.

2)Grass and brush cutting. Let the blade balance at a comfortable clearing height, i.e. close to the ground.

English – 21

Page 21
Image 21
Jonsered GR 2026D, GR 2032D, GR 2036 manual Adjusting the harness and clearing saw, Quick release