ASSEMBLY
Assembling the cutting equipment
WARNING! Never use a cutting attachment
!without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.
Fitting the trimmer guard and trimmer head
•Attach the cord cutter (A) to the trimmer guard using two M5x16 screws, locking washers and nuts as shown.
B
C
A
D
•Fit the guard (B) to the gear housing (C) using the support plate (D) and two screws.
•Turn the output shaft until one of the holes in the drive disk aligns with the corresponding hole in the gear housing.
•Insert the locking pin (E) in the hole to lock the shaft.
E
F
•Screw on the trimmer head (F) in the opposite direction to the direction of rotation.
•Remove the locking pin.
10 – English
