Jonsered GT2123 Assembly, Fitting the main body, Connecting throttle cable and stop switch wires

ASSEMBLY

Fitting the main body

Connect the engine (A) to the tube (B) with four screws (C).

A

C

B

Connecting throttle cable and stop switch wires

1Fit the plastic tube (B) around the throttle cable and stop switch wires as shown.

2Insert the throttle cable through the cable adjuster sleeve on the carburettor bracket. Make sure the end of the throttle cable housing is seated positively in the sleeve.

3Position the slotted fitting on the carburettor so the recessed hole (A) is away from the cable adjuster sleeve.

4Rotate the carburettor throttle cam and slip the throttle cable through the slot in the slotted fitting, making sure the cable lug drops into the recessed hole.

5Press the throttle trigger a few times to check that it works.

6Connect the stop switch wires to the wires from the engine (it is not important which wire is connected to which).

Adjusting the throttle wire

1Loosen the lock-nut (C) and adjust the cable adjuster sleeve (D) so the stop on the carburettor throttle cam just contacts the throttle stop and the cable position keep 1–2 mm play between cable lug and slotted fitting when the throttle trigger is fully depressed.

2When the throttle cable is adjusted correctly, tighten the locking nut (C).

1-2mm

Fitting the handle

1 Place the rubber sleeve A on the shaft B.

B

A

2Position the handle as shown. Fit the mounting components and tighten the handle lightly. Note that the handle must be mounted below the arrow on the shaft.

3Now make a final adjustment to give yourself a comfortable working position. Tighten the screws.

English – 9