Jumpking JKXT12W manual Hole numbers

Step 6:

Lay the jumping mat (bed) inside the frame. Springs are used to support the mat (bed) and are connected between “V” rings on the mat (bed) and holes in the top frame rail. There are 88 “V” rings on the mat (bed) that have to line up with corresponding holes on the top frame rail. These are not numbered. To make sure they eventually all line up, pick an arbitrary point and call it zero or 12 o’clock. Connect a spring between the “V” ring and the frame hole at this point (See Fig. 6).

12 o'clock

Toprail

Mat (bed)

FIGURE 6

Step 7:

Now count 20 holes and “V” rings in a clockwise direction. Attach a spring. You should be at hole 20 or 3 o’clock. Count another 20 holes and “V” rings in a clockwise direction. Attach a spring. You should be at hole 40 or 6 o’clock. Count another 20 holes and “V” rings clockwise and attach a spring. You should be at hole 60 or 9 o’clock. At this point, you should have 4 springs installed at 12, 3, 6, and 9 o’clock (See Fig. 7). This equal tension procedure is essential to properly attach the mat (bed) to the frame.

12 o'clock

0 Clockwise

9 o'clock	Mat (bed)
60		20
		3 o'clock

Hole numbers: 40

6 o'clock

FIGURE 7

Page 18