Jumpking YJ manual Hook the V-ring

3. Lay the Bed (8) on the ground inside of the			8	Frame
assembled frame. Make sure that the two warn-					V-rings
	
ing decals (not shown) are on top of the Bed.
				10
Note: There are V-rings aroundthe edge of the			10		10
Bed (8) and holes around the top of the frame.
				10
During this step, you will attach the Bed to the
frame using the included Springs (10) for holes
on top of frame and for holes on bottom of frame
(see the inset drawing). Hook a spring to the				Holes
Bed(8) and using the spring pulling tool(22), pull
the spring from the Bed to the hole slot in the
trampoline frame with even spring tension.
Be careful where you place your hands, the
Springs and frame joints can pinch.
To attach each Spring, you will first hook one end
of the Spring into a V-ring with black webbing
with yelow line location (see the inset drawing).
No yellow line					22
Black webbing with yellow line
Hook the first two Spring(10) into two the V-rings
(black webbing with yellow line) on the Bed(8) and
into the holes on the top tube. Attach two more
Springs (10) with black with yellow line location
directly across the Bed (with the webbing) from the				Springs (10)	
first two Spring. Attach two	more Spring(10) with
black webbing with yellow line location halfway				Hook the V-ring
between the first/second Spring(10), so eight
Springs(10) are attached as shown. Attach four
more Springs(10) (not shown) halfway between
the first eight Springs(10). Continue attaching
Springs(10) halfway between the previously attached
Springs,until all the Springs are attached.
During the installation of springs, wear
gloves and protective eye wear.				V-ring
					10
				10
				8	Frame
		16