43
EN
INTRODUCTION PREPARATION WATCHING TV
OPTIONAL SETTING OPERATING DVD DVD SETTING TROUBLESHOOTING INFORMATION
English

Stereo Sound Mode

Stereo Sound Mode

CD
This unit allows you to select a sound mode during CD playback.
During playback, press [AUDIO] repeatedly until the
desired sound mode appears.
STEREO
• Each time you press [AUDIO], the sound mode
changes as example below.
STEREO (stereo sound with left and
right channels)
L-ch (left channel sound only)
R-ch (right channel sound only)
Note:
• Virtual surround cannot be changed when the sound mode
is set to either “L-ch” or “R-ch”.

Virtual Surround

Virtual Surround

You can enjoy virtual surround on your 2 channel stereo system.
1During playback, press [MODE] repeatedly until “ ”
appears.
OFF (SURROUND)
2Press [Cursor K / L] to select the sound level.
1
(SURROUND)
1 : Natural effect.
2 : Emphasized effect.
OFF : No effects (original sound).
3Press [BACK] to exit.
Note:
• The setting will be kept even if the unit is turned off.
• For audio CD, virtual surround will not be effective if the
sound mode is set to something other than “STEREO”.
(Refer to “Stereo Sound Mode” on page 43.)
• Turn down the level or select “OFF” if the sound is distorted.

Marker Setup

Marker Setup

This feature allows you to assign a specific point on a disc to be called back later.

To set a marker

1During playback, press [MODE] repeatedly until
“” / “ ” appears.
e.g.) DVD
_ _ /12 (SEARCH)
2Use [Cursor K / L] repeatedly until marker search
menu appears.
123456789
10
AC
3Use [Cursor
s
/
B
] to select an available marker within
60 seconds.
123456789
10
AC
4When the playback reaches the point at which you
want to set a marker, press [ENTER].
• M arker is now set.
23456789
10
AC
5
Press [BACK] to exit.

To return to the marker later

1Repeat steps 1-2 in “To set a marker”.
Use [Cursor
s
/
B
]
to select the desired marker.
e.g.) DVD
23456789
10
AC
2Press [ENTER] at the desired marker to restart playback
from the specific point which you set.
23456789
10
AC
Note:
• Marker search menu will disappear in about 60 seconds
when there is no input.
• You can mark up to 10 points.
• To clear a marker, select the marker to be cleared, and then
press [CLEAR].
• Ejecting the disc or turning off the power will erase all
markers.
• Selecting “ ” at step 3 in the section “To set a marker” will
also erase all markers.