Harman-Kardon HKSB30BLK, SB 30 Subwoofer Phase Switch, Selecting an Input Source, Surround Modes

SB 30

Using Your Soundbar Speaker System

Subwoofer Phase Switch

When the subwoofer is properly in phase with the soundbar speakers, the sound will be clearer and have more impact. In-phase performance will make percussive sounds like drums, piano and plucked strings sound more lifelike. Although there is no absolutely correct setting for the subwoofer’s Phase switch, in most cases it should be left in the “Normal” position. The best way to set the Phase switch is to listen to music that you are familiar with and adjust the switch so that drums and other percussive sounds have maximum impact.

Selecting an Input Source

Press the Source button on the soundbar or the remote control to switch among the three sources: optical digital, coaxial digital and analog.

Source

Button

Source

Button

This area is designed to become quite warm during normal operation

Phase

Switch

Adjusting the System’s Volume

Press the Volume Up and Down buttons on the soundbar or the remote control to raise and lower the system’s volume one step at a time. Hold down the buttons to raise or lower the volume continuously. To mute the system, press the remote control’s Mute button.

Volume Down/Up
Buttons	Mute Button

Volume Down/Up

Buttons

The soundbar’s Status LEDs will glow white to indicate the active source.

Optical Digital

Coaxial Digital

Analog

Surround Modes

Your soundbar incorporates extremely sophisticated digital signal processing that, along with 13 individual transducers powered by 11 amplifier channels, creates an astonishingly realistic surround-sound presentation in any size room, for listeners at any position in the room, without needing any extra speakers or wires.

Press the Surround Mode button on the soundbar or the remote control to switch among the three surround modes: Stereo, Virtual and HARMAN Wave.

Surround Mode

Button

Surround Mode

Button

For the best sound, we recommend turning your TV’s built-in speakers off. Consult your TV’s owner’s manual to find out how to do it. If there is no way to turn your TV’s speakers off, you can adjust your TV’s volume so that the SB 30 system will always supply most of the sound:

1.Using the volume buttons on your TV, turn its volume all the way down.

2.Then use the soundbar’s Volume Up/Down buttons to set the sound to a comfortable listening level.

The soundbar’s Status LEDs glow blue to indicate the active surround mode:

Stereo

Virtual

HARMAN Wave

11