3
Wall Mounting Unit / LCT1500-001A-U / ENGLISH
ENGLISH
Mounting the Wall Unit Warning
■Do not install the Wall
Mounting Unit in a
location which is hot or
humid or which may
become wet, as the
presence of excessive
moisture may lead to fire
or electric shock.
■Do not install the Wall
Mounting Unit near the
blower or air inlet of an
air conditioner.
■Do not install the unit in a
location with a large
amount of dust, soot, or
cigarette smoke, as this
may lead to fire.
■Do not block the
ventilation holes, and be
sure to leave sufficient
space around the unit for
ventilation.
Inadequate ventilation may
cause the unit interior to
overheat, leading to fire.
■Do not install the Wall
Mounting Unit on a non-
vertical wall.
The unit interior may
overheat, resulting in fire,
or the unit may fall down,
causing physical injury.
■Do not install the Wall
Mounting Unit in a
location subject to
frequent vibration, impact
or other external forces.
The unit may fall down or
be damaged, causing
physical injury.
■Do not install the unit in a
location where people
may hang on it or lean
against it.
Doing so may cause the
unit to fall down or be
damaged, resulting in
injury.
■Do not install the unit in a
location exposed to
direct sunlight or strong
light, as viewing the
plasma display in an
overly bright
environment can be tiring
for the eyes.
■The Wall Mounting Unit should be mounted to a wall that can adequately
hold the total weight of the plasma display and the Wall Mounting Unit
over a long period of time and which can adequately withstand
earthquakes, conceivable vibrations, and other external forces.
Improper installation may cause the plasma display to fall down, resulting in
physical injury.
zMounting On Wooden Walls
The weight of the unit should be borne by the wall posts or studs, and these
should be reinforced if insufficiently strong. Do not install the Wall Mounting
Unit on walls made of plasterboard or thin plywood. Use the commercially sold
screws best suited for the wall structure and material.
zMounting On Concrete Walls
Use commercially sold wall anchors capable of supporting the weight of the
plasma display.
Minimum
20 cm
Minimum
15 cm
LCT1500-001A-U.book Page 3 Wednesday, July 9, 2003 2:11 PM
x10