JVC CA-MXGB6, CA-MXGB5 Using Recording Timer, How Recording Timer actually works, On the unit ONLY:, 3 Press CLOCK/TIMER again, 6 Select the preset station

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically. You can set the timer whether the unit is on or off.

How Recording Timer actually works

The unit automatically turns on, tunes in to the specified station, sets the volume level to “VOL MIN,” and starts recording when the on-time comes (the indicator flashes while the timer is operating). Then, when the off-time comes, the unit automatically turns off (stands by).

Recording Timer works only once, but the timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

•If you have made a mistake while setting the timer, press CANCEL/DEMO. (However, this does not always work. If CANCEL/DEMO does not work, press CLOCK/TIMER repeatedly and start from step 2 again.)

Before you start...

Make sure to preset a station you want to record. (See

page 12.)

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press CLOCK/TIMER repeatedly until “REC” appears on the display.

indicator lights up and the REC (recording timer) indicator starts flashing on the display.

WOOFER

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY ON TIME REC

(Daily Timer)

Canceled CLOCK ON TIME

(See page 9.) (Recording Timer)

3 Press CLOCK/TIMER again.

“ON TIME” appears for 2 seconds, then the unit enters on-time setting mode.

WOOFER

4 Set the on-time you want the unit to turn on.

1)Press ¢or 4to set the hour, then press SET/DISPLAY.

2)Press ¢or 4to set the minute, then press SET/

DISPLAY.

“OFF TIME” appears for 2 seconds, then the unit enters off-time setting mode.

5 Set the off-time you want the unit to turn off (on standby).

1)Press ¢or 4to set the hour, then press SET/DISPLAY.

2)Press ¢or 4to set the

minute, then press SET/DISPLAY. The unit enters preset station selecting mode.

6 Select the preset station.

1) Press ¢or 4to select the band (“TUNER FM” or “TUNER AM”), then press

SET/DISPLAY.

2)Press ¢or 4to select a

preset channel number, then press SET/DISPLAY.

The REC (recording timer)

indicator stops flashing and remains lit. The settings you have done are shown on the display in sequence for your confirmation.

7 Press STANDBY/ON to turn off the unit (on standby) if necessary.

About the recording source

If you change the source while recording, the recording source also changes.

27