Manuals / Brands / Home Audio / Stereo Receiver / JVC / Home Audio / Stereo Receiver

JVC CA-MXGB6, CA-MXGB5 Unpacking, Connecting Antennas, FM antenna, To connect an outdoor FM antenna, Getting Started, 2Extend the FM antenna

1 36

Download 36 pages, 2.31 Mb

Getting Started	have been made.	Continued
	Do not connect the AC power cord until all other connections

Unpacking

After unpacking, check to be sure that you have all the following items.

The number in the parentheses indicates the quantity of the pieces supplied.

•AM (MW) loop antenna (1)

•FM antenna (1)

•Remote control (1)

•Batteries (2)

If any is missing, consult your dealer immediately.

Putting the Batteries into the Remote Control

Insert the batteries—R6P(SUM-3)/AA(15F)—into the remote control, by matching the polarity (+ and –) on the batteries with the + and – markings on the battery compartment. When the remote control can no longer operate the unit, replace both batteries at the same time.

1

2 R6P(SUM-3)/AA(15F)

3

•DO NOT use an old battery together with a new one.

•DO NOT use different types of batteries together.

•DO NOT expose batteries to heat or flame.

•DO NOT leave the batteries in the battery compartment when you are not going to use the remote control for an extended period of time. Otherwise, it will be damaged from battery leakage.

Connecting Antennas

FM antenna

FM antenna (supplied)

ANTENNA	AM

FM	[75	]

1Attach the FM antenna to the FM [75 Ω] coaxial terminal.

2Extend the FM antenna.

3Fasten it up in the position which gives you the best reception, then fix it on the wall, etc.

About the supplied FM antenna

The FM antenna supplied with this unit can be used as temporary measure. If reception is poor, you can connect an outdoor FM antenna.

To connect an outdoor FM antenna

Before connecting it, disconnect the supplied FM antenna.

Outdoor FM antenna (not supplied)

ANTENNA	AM

FM	[75	]

A 75 Ω antenna with coaxial type connector (DIN 45325) should be used.

6

Contents

INSTRUCTIONS Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS G-1 SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” G-2 Introduction About This Manual Precautions Installation Power sources Contents Location of the Buttons and Controls Front Panel Display Window Front Panel Remote Control Remote Control Unpacking Connecting Antennas FM antenna To connect an outdoor FM antenna AM (MW) antenna Connecting Speakers To connect an outdoor AM (MW) antenna Connecting Other Equipment Canceling the Display Demonstration To connect audio equipment To start the display demonstration manually Common Operations Turning On or Off the Power Saving the Power Consumption While on Standby—ECOMode Setting the Clock To check the clock time Selecting the Sources Reinforcing the Bass Sound Adjusting the Volume To turn down the volume level temporarily Enjoying the Powerful Sound—RHYTHMAX Selecting the Sound Modes Turning On or Off the Key-touchTone Listening to the Radio Tuning in to a Station—AutoSearch To change the FM reception mode Presetting Stations Tuning in to a Preset Station Receiving FM Stations with RDS Changing the RDS Information Searching for Programs by PTY Codes (PTY Search) Switching Temporarily to a Program Type of Your Choice Playing Back CDs Loading CDs Playing Back CDs—AllDisc and One Disc All Disc play •When the MP3 playback mode is the ALBUM mode (See also page 19.) •When the MP3 playback mode is the TRACK mode (See also page 19.) To stop during play, press To remove the disc, press CD One Disc play Basic CD Operations To exchange CDs during playback of another To skip to another CD in the carrousel To stop play for a moment To locate a particular point in a track To go to another album on an MP3 disc To go to another track directly using the number buttons Changing the MP3 Playback Mode Turning On or Off the Resume Play for MP3 Disc Programming the Playing Order of the Tracks —–ProgramPlay To modify the program Playing at Random—–RandomPlay Repeating Tracks or CDs—–RepeatPlay Prohibiting Disc Ejection—–CarrouselLock Playing Back Tapes Playing Back a Tape Recording IMPORTANT: To protect your recording Recording a Tape on Deck B Dubbing Tapes CD Synchronized Recording Using the Timers Using Daily Timer How Daily Timer actually works To turn on or off Daily Timer after its setting is done Using Recording Timer How Recording Timer actually works To turn on or off Recording Timer after its setting is done Using Sleep Timer How Sleep Timer actually works Timer Priority Maintenance Cleaning the unit Handling discs Handling cassette tapes Additional Information Description of the PTY codes: Troubleshooting Specifications CA-MXGB6 CA-MXGB5 Tuner CD player SYSTEM COMPONENT COMPACT MXGB5-MXGB6/CA-CA