JVC UX-P4R, CA-UXP6R, UX-P6R Connecting Speakers, 1Connect the AM loop antenna to the AM, terminal

AM (MW/LW) antenna Connecting Speakers

]]

1	2
	3

ANTENNA

1

Vinyl-covered wire (not supplied)

For UX-P6R and UX-P5R Red

AM EXT

AM LOOP

FM 75

COAXIAL

2

AM loop antenna (supplied)

1Connect the AM loop antenna to the AM

LOOP terminals as illustrated.

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM (MW/LW) antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

RIGHT	LEFT
	MAIN
Speaker	SPEAKERS	Speaker
cord		cord
SPEAKER
IMPEDANCE	Black
MIN 6
For UX-P4R and UX-P3R
	Red
RIGHT	LEFT
MAIN
SPEAKERS
Speaker		Speaker
cord		cord
SPEAKER
IMPEDANCE
MIN 4	Black
Right	Left
speaker	speaker

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity of the speaker terminals: Red (+) to red (+) and black (–) to black (–).

For better reception of both FM and AM (MW/LW)

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

3Release the finger from the clamp.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –