ENGLISH
Mounting on a commercially available board
After step 1, use screws to secure the unit on the commercially available board. In this case, the mounting bracket C need not be used.
Horizontal installation | Vertical installation | |
Tapping screw | Tapping screw | |
(Dia. 3/16 inch c 13/16 inch | ||
(Dia. 3/16 inch c 13/16 inch | ||
/ M 4 mm c 20 mm) c 4 | ||
/ M 4 mm c 20 mm) c 4 | ||
|
Board (Commercially available
item: Thickness 23/32 inch / 18 mm and above)
Board (Commercially available
item: Thickness 23/32 inch / 18 mm and above)
Attaching the remote controller
Do not place the remote controller where it will be exposed to direct sunlight.
How to use the wire clamp
To prevent the remote control cord or the L- shaped pin plug relay cord from falling off due to vibration, secure all cords with the attached wire clamp after all connection is completed.
Allow the
Power cord
pin plug relay to sag
slightly
Pull
Wire clamp
Remote controller cord leave a little longer
Peel off the sheet
•Clean the item thoroughly before attaching.
8