DLA-G150HTE
1-10 No.51847
16
Installing the Projector
Adjusting the Inclination of the Projector
The vertical angle and the leveling of the projector can be adjusted with the adjustable feet at the bottom of the projector.
■
Adjusting the vertical angle of the projector
While pushing the levers on both sides upward, raise the projector. The adjustable feet automatically extend.
To retract the feet, push the levers and lower the projector slowly; the projector is fixed at the position
where you release the levers.
■
Leveling the projector
Lift the projector, rotate the rear adjustable foot, and adjust the horizontal angle until the projector is level.
Y
P
B
/B-Y
P
R
/R-Y
H
V
G
B
R
REMOTE
RS-232C
Y/C VIDEO
Adjustable feet (at the front)
lever
ShortenExtend
Adjustable foot (at the rear)
Fixing foot (at the rear)
15
ENGLISHDEUTSHFRANÇAISITALIANOESPAÑOL
Installing the Projector
Precautions for Installation
CAUTIONS
1. Before instalation, do not connect the projector’s power cord.
2. Do not install the projector in the following places:
•Where there is water, humidity or dust.
•Where the projector may be subjected to oil, smoke or cigarette smoke.
•On a soft surface such as a carpet or cushion.
•Where the projector may be subjected to direct sunlight.
•Where temperature is high or humidity is low.
Allowable operation temperature range: 41°F to 95°F (+5°C to +35°C)
Allowable relative humidity range: 20% to 80% (no condensation)
Allowable storage temperature range: 14°F to 140°F (–10°C to +60°C)
■
When installing the projector, observe the following:
•Do not use the projector placed on its side.
Avoid using the projector placed on its side. This could cause a malfunction.
•Use the projector within the specified angle.
Do not use the projector inclined ±30° horizontally (left/right). This could cause color variation or shorten the lamp life.
•Do not block the exhaust vents.
Do not use a cover which encloses the projector air-tight or blocks the exhaust vents. Allow sufficient space around the
projector. When the projector is enclosed in a space of the following dimensions, use an air conditioner so the temperature
inside becomes equal to the outside temperature.
Allowable minimum space required
600mm
200mm
300mm
300mm
200mm