JVC DILA projector Firmware Update Instructions
OUTLINE
This document describes how to update the firmware in the following JVC DILA projectors:
EQUIPMENT REQUIRED
To carry out the firmware update, you will need:
∙The JVC update program installer: “X3_V1_3.EXE”
∙A Standard PC running Windows XP™ or Later with a USB Port.
∙A USB to Mini USB cable.
∙A crosshead screwdriver.
INSTALL USB DRIVER
If you are reading this, you should now have the JVC DILA Projector Update Software installed on your PC. The next step is to install the USB driver so that your PC can communicate with the projector via the USB connection. You only need to do this once. You will require Administrator level access to the PC to proceed.
During the driver installation, you may receive a message informing you that the driver has not passed Windows Logo testing. If you receive this message, click on “Continue Anyway” to proceed with the installation.
To install the drivers:
1.Switch the projector off and unplug the mains lead from the connector on the side of the projector. Wait for the Standby light to go out.
2.Undo the screw and remove the cover next to the Trigger socket on the projector. This will reveal two small connectors, one of which is a Mini USB Socket.
3.Plug one end of the USB cable into a USB socket on your PC and the other end into the Mini USB socket on the projector.
4.Hold down the Standby/On button on the projector and plug the mains lead back in while still holding the button down. The three LEDs on the projector should all light to show that the projector is in Download Mode.
5.The PC should detect the projector as new hardware (it will detect it as “ILA- FPJ Interface”). It should then run the Found New Hardware Wizard to help you install the drivers. To install the drivers, follow the steps shown on the next two pages.
These instructions show how to install the driver with Windows XP. If you are using Windows Vista or Later version, there are only two screens. The first is to inform you that the driver has not passed Windows Logo testing and the second to confirm that you wish to install the driver.
Page 1 of 6
