JVC DILA projector Firmware Update Instructions
Click “OK” to continue.
The program will then show that the transfer is complete and, after
After this happens, press the Standby/On button on the projector. The three LEDs will flash slowly for around
CHECK FIRMWARE VERSION
To check that the firmware has been updated correctly, leave the USB cable connected, switch the projector on as normal and wait for it to display a picture or the blue background. Once it has displayed a picture, click the “Get Ver.” Button in the update program. After a few seconds, the Updater Program will display the firmware version. If the update has been successful, the version number should be “ver 1.3”.
If the Updater Program doesn’t display “ver 1.3”, the update has not been successful and you should repeat the update from the top of Page 4 above.
To finish the update, switch off the projector and wait until the Standby LED has stopped flashing, then remove the mains lead from the projector, remove the USB cable, refit the connector cover, plug the mains lead back in, switch on and enjoy.
Produced by JVC (ver1.3)
Page 6 of 6
