JVC FS-H10C Tuning in to a Station, To change the FM reception mode, To reduce the beat—BeatCut, “FM” or “AM.”, On the remote control ONLY:, On the remote control ONLY:

Listening to FM and AM Broadcasts

English

Tuning in to a Station

1 Press TUNER/BAND to select either TUNER

/BAND

“FM” or “AM.”

The unit automatically turns on and tunes in to the previously received station—either FM or AM.

•Each time you press the button, the band alternates between FM and AM.

To change the FM reception mode

On the remote control ONLY:

When an FM stereo broadcast is hard to receive REPEAT

ST/MONO

or noisy, press REPEAT ST/MONO so that the MONO indicator lights up on the display. Reception will improve.

To restore the stereo effect, press REPEAT ST/MONO again so that the MONO indicator goes off. In stereo mode, you can hear stereo sound when a stereo program is broadcast.

2 Press and hold ¢or 4 (or ¡/¢or 4/1on the unit) for more than 1 second.

•	¢(¡/¢):	Increases the frequencies.
•	4(4/1):	Decreases the frequencies.

The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.

•If an FM program is broadcast in stereo, the ST (stereo) indicator lights up on the display (only when the reception is good).

To stop during searching, press ¢or 4(or ¡/¢or 4/1on the unit).

When you repeatedly press ¢or 4(or ¡/¢or 4/1on the unit)

The frequency changes step by step.

To reduce the beat—Beat Cut

On the remote control ONLY:

If the beats are heard while listening a

broadcast, press BEAT CUT.

BEAT CUT

10