English
■4. Press the UP, DOWN, >, or < button within 5 seconds to select the preset number.
UP or > button: Increases the preset number by 1.
DOWN or < button: Decreases the preset number by 1.
•When the > or < button is kept pressing, the preset number changes rapidly.
■5. Press the SET button within 5 seconds.
“STORED” appears and after 2 seconds, the display returns to the broadcast frequency display.
■6. Repeat above steps 1 to 5 for each station you want to store in memory with a preset number.
To change the preset stations, repeat the same steps as
above.
Auto Presetting
In each band, you can automatically preset
| AUTO | |
TUNER | PRESET | |
(for 2 seconds) | ||
BAND |
■1. Select a band by pressing the TUNER
BAND button.
■2. Press the AUTO PRESET button on the
Remote Control for more than two sec- onds.
■3. Repeat steps 1-2 for the other band.
■If you want to change the preset stations, carry out the Manual Presetting for the desired preset numbers.
CAUTION: Even if the system is unplugged or if the power failure occurs, the preset stations will be stored for about 24 hours. However, in case the preset stations are erased, you will need to preset the stations again.
To Change the FM
Reception Mode
When you are tuned into an FM stereo broadcast, the “STEREO” in- dicator lights up and you can hear stereo effects.
If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose stereo effect.
Press the FM MODE button on the Remote Control so that the “MONO” indicator lights up on the display.
| FM MODE |
STEREO | MONO |
To restore the stereo effect, press the FM MODE button on the
Remote Control so that the “MONO” indicator goes off.
9