22
Troubleshooting

If you are having a problem with your System, check this

list for a possible solution before calling for service. If you cannot solve the problem from the hints given

here, or the System has been physically damaged, call a

qualified person, such as your dealer, for service.

Specifications
Symptom Possible Cause Action
No sound is heard. Connections are incorrect, or loose.
Headphones are connected.
Check all connections and make correc-
tions. (See pages 4 to 8.)
Disconnect the headphones.
Poor radio reception The antenna is disconnected.
The AM Loop Antenna is too close to the
System.
The FM Wire Antenna is not properly
extended and positioned.
Reconnect the antenna securely.
Change the position and direction of the
AM Loop Antenna.
Extend FM Wire Antenna to the best
reception position.
The CD skips. The CD is dirty or scratched. Clean or replace the CD.
The CD does not play. The CD is upside down. Put the CD in with the label side up.
Unable to operate the Remote Control. The path between the Remote Control
and the sensor on the Unit is blocked.
The batteries have lost their charge.
Remove the obstruction.
Replace the batteries.
Operations are disabled. The built-in microprocessor has malfunc-
tioned due to external electrical interference. Unplug the System then plug it back in.
"NO DISC" or "0:00" appears.
There is no disc in the tray, or CD, CD-R or
CD-RW that hasn’t yet been finalized (in-
cluding blank discs) has been inserted.
Insert a CD, CD-R or CD-RW that has been
finalized.
Subwoofer automatically turns on, but no
sound is output. The volume knob of the Subwoofer is set to
MIN position. Adjust the volume knob.
Subwoofer does not automatically turn on. The volume knob of the Subwoofer is set to
MIN position. Also, the volume level of the
Unit is low.
Adjust both volume levels.
CA-FSSD1000
Amplifier
Output Power 38W (19 W + 19 W) at 4 (Max.)
30W (15 W + 15 W) at 4 (10% THD)
Input Sensitivity/Impedance (1 kHz)
MD/AUX IN 500 mV/47 k
Output Sensitivity/Impedance (1 kHz)
MD/AUX OUT 500 mV/5 k
CD DIGITAL OUT –21 dBm - –15 dBm
(Optical out)
Speaker terminals 4 - 16
Subwoofer out 440 mV/6 k
Phones 16 - 1 k
0 - 15 mW/ch output into 32
CD Player
Signal-To-Noise Ratio 100 dB (typical) (94 dB (MIN))
Wow And Flutter Unmeasurable
Tuner
FM Tuner
Tuning Range 87.5 MHz - 108.0 MHz
AM Tuner
Tuning Range (MW) 522 kHz - 1 629 kHz
(LW) 144 kHz - 288 kHz
Power Specifications
Power Requirements AC 240 V ~ , 50 Hz
Power Consumption 25 W (power on mode)
1.9 W (in Standby mode)
Center Unit
Dimensions 300mm 75mm 215mm (W/H/D)
Mass Approx. 3.0kg
Speaker Specifications (each unit)
SP-FSSD1000
Speakers 9.5cm 1cm dome
Impedance 4
Dimensions 125mm 315mm 125mm (W/H/D)
Mass 520g
Powered Subwoofer (SP-PW1000)
Speaker Woofer 16 cm (4 ) 1
Rated Impedance 4
Frequency Response 30 Hz - 280 Hz
Output sound pressure level82 dB/W-m
Input sensitivity/Impedance
LOW LEVEL 500 mV/50 k
HIGH LEVEL 2.1 V/1 k
Output Power 90 W at 4 (Max.)
60 W at 4 (10% THD)
Power requirements AC 240 V ~, 50 Hz
Power consumptions 30 W
Dimensions 226mm 295mm 315 mm (W/H/D)

Mass 7.7 kg

Accessories Power Cord (1)
AM Loop Antenna (1)
Remote Control (1)
Batteries R6P (SUM-3)/AA (15F) (2)
FM Wire Antenna (1)
Signal Cord (1)
Spacers (4) (for SP-PW1000)
Design and specifications are subject to change without notice.
VICTOR COMPANY OF JAPAN, LIMITED
0301MNMCREHIT
EN
FS-SD1000_01E.book Page 22 Thursday, March 29, 2001 1:27 PM