Command list
●“*” is the monitor ID. Normally, set it to “0x80”.
●Enter the appropriate data to “xx” or “x”.
No. | Operation commands |
|
| ||||
1† | ! | 0x82 | * | P | W | x | Lf |
2† | ! | 0x82 | * | I | P | x | Lf |
3† | ! | 0x82 | * | V | L | x | x Lf |
4† | ! | 0x82 | * | A | M | x | Lf |
5† | ! | 0x82 | * | V | S | x | Lf |
6† | ! | 0x82 | * | A | S | x | Lf |
|
|
|
7 | ! | 0x82 | * | R | C | x | x | x | x | Lf |
8 | ! | 0x82 | * | S | U | I | C | x | x | Lf |
9 | ! | 0x82 | * | S | U | R | M | x | Lf |
|
10†† | ! | 0x82 | * | S | U | F | K | x | Lf |
|
†For these commands, you can make enquiry commands by entering “?” instead of “!” and omitting the data bytes. When you send an enquiry command, the monitor sends back an acknowledge, then an answer about its current status.
††When you change this setting, setting of “Front Panel Lock” (➔ page 27) is also changed accordingly.
42