Connections

PC Input Terminals connection

COMPUTER

AUDIO

PC IN

Conversion adapter

Less than

Ferrite core (large size)

3" 15/16

(if necessary)

 

(supplied)

 

 

(10 cm)

mini D-sub 15p

 

 

 

RGB

 

 

 

PC cable

 

Ferrite core (small size)

Less than

 

3" 15/16

 

 

(supplied)

(10 cm)

Audio

Stereo plug

Connect a cable which matches

the audio output terminal on the computer.

Installing the ferrite core (Small size)

12

Pull back the tabs

(in two places)

Installing the ferrite core (Large size)

12

Pull back the tabs (in two places)

3

Open

Press the cable through and close

3

Open

Press the cable through and close

Notes:

(1)Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)

(2)The display resolution is a maximum of 768 ⋅ 768 dots (GD-V422PCE), 1,024 ⋅ 768 dots (GD-V502PCE) when the aspect mode is set to “4:3”, and 1,024 ⋅ 768 dots (GD-V422PCE), 1,366 ⋅ 768 dots (GD-V502PCE) when the aspect mode is set to “16:9”. If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.

(3)The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will need to make setting changes to the computer at the time of connection.

(4)Some PC models cannot be connected to the set.

(5)There is no need to use an adapter for computers with DOS/V compatible mini D-sub 15P terminal.

(6)The computer shown in the illustration is for example purposes only.

(7)Additional equipment and cables shown are not supplied with this set.

(8)Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified frequency range.

(9)Component Input is possible with the pin 1, 2, 3 of the mini D-sub 15P Connector.

Signal Names for mini D-sub 15P Connector

11 12 13 14 15

6 7 8 9 10

1 2 3 4 5

Pin Layout for PC Input Terminal

Pin No.

Signal Name

Pin No.

Signal Name

Pin No.

Signal Name

1

R (PR/CR)

6

GND (Ground)

11

GND (Ground)

2

G (Y)

7

GND (Ground)

12

SDA

3

B (PB/CB)

8

GND (Ground)

13

HD/SYNC

4

GND (Ground)

9

NC (not connected)

14

VD

5

GND (Ground)

10

GND (Ground)

15

SCL

8