JVC GET0697-001A, KD-S17 SETTINGS, TROUBLESHOOTING, SPECIFICATIONS, Sound adjustments, Adjusting the sound, General settings—PSM, INSTRUCTIONS, Audio amplifier section, General, notice

SETTINGS

Sound adjustments

Preset values	BAS	MID	TRE	LOUD
Indication (For)	(bass)	(mid-range)	(treble)	(loudness)
USER (Flat sound)	00	00	00	OFF
ROCK (Rock or disco music)	+03	00	+02	OFF
CLASSIC (Classical music)	+01	00	+03	OFF
POPS (Light music)	+02	+01	+02	OFF
HIP HOP (Funk or rap music)	+04	–02	+01	OFF
JAZZ (Jazz music)	+03	00	+03	OFF

Adjusting the sound

BAS*2 (bass)		: Adjust the bass.	–06 to +06
MID*2 (mid-range)		: Adjust the middle frequencies sound level.	–06 to +06
TRE*2 (treble)		: Adjust the treble.	–06 to +06
FAD*3 (fader)		: Adjust the front and rear speaker balance.	R06 to F06
BAL (balance)		: Adjust the left and right speaker balance.	L06 to R06
LOUD*4 (loudness)		: Boost low and high frequencies to produce a well-balanced sound	LOUD ON or LOUD OFF
		at a low volume level.
SUB.W (subwoofer)		: Adjust the subwoofer output level.	00 to 08
VOL (volume)		: Adjust the volume.	00 to 50 (or 00 to 30)*5
*1	Displayed only when “L/O MODE” is set to “WOOFER.”
*2	When you adjust the bass, mid-range, or treble, the adjustment you have made is stored for the currently selected sound
*3	mode (iEQ) including “USER.”
	If you are using a two-speaker system, set the fader level to “00.”
*4	The adjustment made (LOUD ON/LOUD OFF) will be applied to all sound modes (iEQ).
*5	Depending on the amplifier gain control setting.

General settings—PSM

Enter PSM menu. Select an item. Adjust. Finish.

TROUBLESHOOTING

	Symptoms		Remedies/Causes
	• Sound cannot be heard from the speakers.		• Adjust the volume to the optimum level.
General			• Check the cords and connections.
	• The buttons on the unit do not work as you		If you press M MODE, some buttons work differently from its
		intended.	original function. Wait for 5 seconds or press M MODE again.
	• This unit does not work at all.		Reset the unit.
FM/AM	• SSM automatic presetting does not work.		Store stations manually.
	• Static noise while listening to the radio.		Connect the antenna firmly.
	•	Disc ejects.	Insert the disc correctly.
	• CD-R/CD-RW cannot be played back.		• Insert a finalized CD-R/CD-RW.
	• Tracks on the CD-R/CD-RW cannot be		• Finalize the CD-R/CD-RW with the component which you used
		skipped.	for recording.
playback
	• Disc can be neither played back nor ejected.		• Unlock the disc.
			• Eject the disc forcibly.
Disc
	• Disc sound is sometimes interrupted.		• Stop playback while driving on rough roads.
			• Change the disc.
			• Check the cords and connections.
	• “NO DISC” appears on the display.		Insert a playable disc into the loading slot.
	• “PLEASE” and “EJECT” appear alternately
		on the display.
	• Disc cannot be played back.		• Use a disc with MP3/WMA tracks recorded in a format compliant
			with ISO 9660 Level 1, Level 2, Romeo, or Joliet.
			• Add the extension code <.mp3> or <.wma> to the file names.
	•	Noise is generated.	Skip to another track or change the disc. (Do not add the extension
playback			code <.mp3> or <.wma> to non-MP3 or WMA tracks.)
	• A longer readout time is required		Do not use too many hierarchical levels and folders.
		(“READING” keeps flashing on the display).
MP3/WMA
	• Tracks are not played back in the order you		Playback order is determined when the files are recorded.
		have intended.
	• The elapsed playing time is not correct.		This sometimes occurs during playback. This is caused by how the
			tracks are recorded on the disc.
	• The correct characters are not displayed		This unit can only display alphabets (upper case), numbers, and a
		(e.g. album name).	limited number of symbols.

• Microsoft and Windows Media are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.

INSTRUCTIONS

Indication

Item ( : Initial)

Setting

SPECIFICATIONS

DEMO

•

DEMO ON

:

Display demonstration will be activated automatically if no operation is done

for about 20 seconds.

DEMO OFF

Audio amplifier section

CD player section

•

:

Cancels.

CLK DISP*6

•

ON

:

Clock time is shown on the display at all times when the power is turned off.

Power Output:

Type:

Compact disc player

•

OFF

: Cancels; pressing DISP will show the clock time for about 5 seconds when the

20 W RMS × 4 Channels at 4 Ω and

Signal Detection System:

Non-contact optical pickup

power is turned off.

≤ 1% THD+N

(semiconductor laser)

CLOCK H (Hour)

1 – 12

:

[Initial: 1 (1:00)]

Signal-to-Noise Ratio:

Number of channels:

2 channels (stereo)

80 dBA (reference: 1 W into 4 Ω)

Frequency Response:

5 Hz to 20 000 Hz

CLOCK M (Minute)

00 – 59

:

[Initial: 00 (1:00)]

Dynamic Range:

93 dB

DIMMER

•

ON

:

Dims the display and button illumination.

Load Impedance:

4 Ω (4 Ω to 8 Ω allowance)

Signal-to-Noise Ratio:

98 dB

•

OFF

: Cancels.

Tone Control Range:

Bass:

±12 dB at 60 Hz

Wow and Flutter:

Less than measurable limit

SCROLL*7

•

ONCE

:

Scrolls the displayed information once.

Mid-range: ±12 dB at 1 kHz

MP3 Decoding Format:

MPEG1/2 Audio Layer 3

Max. Bit Rate: 320 kbps

•

AUTO

:

Repeats scrolling (at 5-second intervals).

Treble:

±12 dB at 7.5 kHz

WMA (Windows Media® Audio) Decoding Format :

•

OFF

: Cancels.

Frequency Response:

40 Hz to 20 000 Hz

Max. Bit Rate: 192 kbps

•

Pressing DISP for more than one second can scroll the display regardless of

Line-Out Level/Impedance:

2.5 V/20 kΩ load (full scale)

the setting.

Output Impedance:

1 kΩ

Subwoofer-Out Level/Impedance:

L/O MODE

•

REAR

:

Select if the REAR LINE OUT terminals are used for connecting the speakers

General

2.5 V/20 kΩ load (full scale)

(through an external amplifier).

WOOFER

Power Requirement: Operating Voltage: DC 14.4 V

•

:

Select if the REAR LINE OUT terminals are used for connecting a subwoofer.

(11 V to 16 V allowance)

WOOFER*8

•

LOW

: Frequencies lower than 90 Hz are sent to the subwoofer.

Tuner section

Grounding System: Negative ground

•

MID

:

Frequencies lower than 135 Hz are sent to the subwoofer.

Frequency Range:

Allowable Operating Temperature:

•

HIGH

:

Frequencies lower than 180 Hz are sent to the subwoofer.

0°C to +40°C (32°F to 104°F)

FM: 87.5 MHz to 107.9 MHz

AUX ADJ

A.ADJ 00

:

Adjust the auxiliary input level to avoid the sudden increase of the output

Dimensions (W × H × D):

(with channel interval set to 100 kHz or 200 kHz)

– A.ADJ 05

level when changing the source from external component connected to the

87.5 MHz to 108.0 MHz

Installation Size (approx.):

AUX input jack on the control panel.

(with channel interval set to 50 kHz)

182 mm × 52 mm × 160 mm

AM: 530 kHz to 1 710 kHz

(7-3/16” × 2-1/16” × 6-5/16”)

TAG DISP

•

TAG ON

: Shows the Tag while playing MP3/WMA tracks.

Panel Size (approx.):

•

TAG OFF

:

Cancels.

(with channel interval set to 10 kHz)

188 mm × 58 mm × 6 mm

531 kHz to 1 602 kHz

AMP GAIN*9

•

LOW PWR

: VOL 00 – VOL 30 (Select if the maximum power of each speaker is less than

(7-7/16” × 2-5/16” × 1/4”)

(with channel interval set to 9 kHz)

50 W to prevent damaging the speaker.)

Mass (approx.):

HIGH PWR

[FM Tuner]

•

:

VOL 00 – VOL 50

1.3 kg (2.9 lbs) (excluding accessories)

AREA

•

AREA US

:

When using in North/Central/South America. AM/FM intervals are set to

Usable Sensitivity: 9.3 dBf (0.8 μV/75 Ω)

Design and specifications are subject to change without

50 dB Quieting Sensitivity: 16.3 dBf (1.8 μV/75 Ω)

10 kHz/200 kHz.

AREA EU

Alternate Channel Selectivity (400 kHz): 65 dB

notice.

•

: When using in any other areas. AM/FM intervals are set to 9 kHz/50 kHz

Frequency Response: 40 Hz to 15 000 Hz

(100 kHz during auto search).

AREA SA

Stereo Separation: 40 dB

•

: When using in South American countries where FM interval is 100kHz.

AM interval is set to 10kHz.

[AM Tuner]

Having TROUBLE with operation?

*6

If the power supply is not interrupted by turning off the ignition key of your car, it is recommended that you select “OFF” to

Sensitivity/Selectivity: 20 μV/40 dB

Please reset your unit

save the car’s battery.

*7

Some characters or symbols will not be shown correctly (or will be blanked) on the display.

Still having trouble??

*8

Displayed only when “L/O MODE” is set to “WOOFER.”

If a kit is necessary for your car, consult your telephone

Call 1-800-252-5722 (USA ONLY)

*9

The volume level automatically changes to “VOL 30” if you change to “LOW PWR” while the volume level is set higher than

directory for the nearest car audio speciality shop.

http://www.jvc.com

“VOL 30.”3– EN