Preparing the remote controller

When you use the remote controller for the first time, pull out the insulation sheet.

Insulation sheet

For USA-California Only:

This product contains a CR Coin Cell Lithium Battery which contains Perchlorate Material— special handling may apply. See www.dtsc. ca.gov/hazardouswaste/perchlorate

If the effectiveness of the remote controller decreases, replace the battery.

Replacing the lithium coin battery

CR2025

KD-R528/KD-A525/KD-R428 is equipped with the steering wheel remote control function.

For details, refer also to the instructions supplied with the remote adapter.

Caution:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

Battery shall not be exposed to excessive heat such as sunshine, fire, or the like.

Warning (to prevent accidents and damage):

Do not install any battery other than CR2025 or its equivalent.

Do not leave the remote controller in a place (such as dashboards) exposed to direct sunlight for a long time.

Store the battery in a place where children cannot reach.

Do not recharge, short, disassemble, heat the battery, or dispose of it in a fire.

Do not leave the battery with other metallic materials.

Do not poke the battery with tweezers or similar tools.

Wrap the battery with tape and insulate when throwing away or saving it.

About discs

This unit can only play the CDs with:

Discs that cannot be used:

Discs that are not round.

Discs with coloring on the recording surface or discs that are dirty.

You cannot play a Recordable/ReWritable disc that has not been finalized. (For the finalization process refer to your disc writing software, and your disc recorder instruction manual.)

3-inch CD cannot be used. Attempt to insert using an adapter can cause malfunction.

Handling discs:

Do not touch the recording surface of the disc.

Do not stick tape etc. on the disc, or use a disc with tape stuck on it.

Do not use any accessories for the disc.

Clean from the center of the disc and move outward.

Clean the disc with a dry silicon or soft cloth. Do not use any solvents.

When removing discs from this unit, pull them out horizontally.

Remove the rims from the center hole and disc edge before inserting a disc.

ENGLISH 5